Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2017.09–2021.02
RM33A0E _54 Brake _065365 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0327182 VEHICLE STABILITY CONTROL SYSTEM T

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


If there are no DTCs output and the problem still occurs, check the suspected areas for each problem symptom in the order given in the following table and proceed to the relevant troubleshooting page.

NOTICE:

When replacing the skid control ECU (brake actuator assembly), sensors, etc., turn the ignition switch off.


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Vehicle Stability Control System
Symptom Suspected Area Link
ABS warning light abnormal (Remains on) Refer to the procedure for "ABS Warning Light Remains ON" Click here
ABS warning light abnormal (Does not come on) Refer to the procedure for "ABS Warning Light does not Come ON" Click here
Brake system warning light (red indicator) abnormal (Remains on) Refer to the procedure for "Brake Warning Light Remains ON" Click here
Brake system warning light (red indicator) abnormal (Does not come on) Refer to the procedure for "Brake Warning Light does not Come ON" Click here
Brake hold standby indicator light abnormal Refer to the procedure for "Brake Hold Standby Indicator Light Circuit" Click here
Brake hold operated indicator light abnormal Refer to the procedure for "Brake Hold Operated Indicator Light Circuit" Click here
Slip indicator light abnormal (Remains on) Refer to the procedure for "Slip Indicator Light Remains ON" Click here
Slip indicator light abnormal (Does not come on) Refer to the procedure for "Slip Indicator Light does not Come ON" Click here
TRC does not operate Refer to the procedure for "TRC does not Operate" Click here
Excessive brake pedal travel (No fluid leaks and no air in system) Refer to the procedure for "Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)" Click here
ABS operates before necessary when braking Refer to the procedure for "ABS Operates Before Necessary When Braking" Click here
VSC does not operate or VSC does not operate correctly Refer to the procedure for "VSC does not Operate or VSC does not Operate Correctly" Click here
Brake actuator operation sound is loud during initial check Refer to the procedure for "Brake Actuator Operation Sound is Loud during Initial Check" Click here
VSC OFF switch abnormal Refer to the procedure for "VSC OFF Switch Circuit" Click here