| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0234 | Actual turbocharger pressure is deviated 100 kPa (750 mmHg, 29.5 in.Hg) or more from the simulated target pressure for 60 seconds
(1 trip detection logic) |
·
Open or short in VN turbo actuator circuit ·
Turbocharger sub-assembly ·
Turbocharger actuator (built into turbocharger sub-assembly) ·
EGR valve assembly ·
Mass air flow meter sub-assembly ·
Manifold absolute pressure sensor ·
Vacuum hose ·
Exhaust system is clogged ·
ECM |
| P0299 | Actual turbocharger pressure is deviated -50 kPa (-100 mmHg, -14.8 in.Hg) to -100 kPa (-750 mmHg, -29.5 in.Hg) or more from the simulated target pressure for 50 seconds
(1 trip detection logic) |
·
Open or short in VN turbo actuator circuit ·
Turbocharger sub-assembly ·
Turbocharger actuator (built into turbocharger sub-assembly) ·
EGR valve assembly ·
Mass air flow meter sub-assembly ·
Manifold absolute pressure sensor ·
Exhaust system and intake system are modified or clogged ·
ECM |
| P1251 | Actual turbocharger pressure is deviated 40 kPa (300 mmHg, 11.8 in.Hg) or more from the simulated target pressure for 0.5 seconds
(1 trip detection logic) |
·
Open or short in VN turbo actuator circuit ·
Turbocharger sub-assembly ·
Turbocharger actuator (built into turbocharger sub-assembly) ·
EGR valve assembly ·
ECM |
Refer to DTC P0045 (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>P0045).
Inspect the fuses of this circuits related to this system before performing the following procedure.
After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read DTCs.
| Result | Proceed to |
|---|---|
| P0234, P0299 and/or P1251 | A |
| P0234, P0299 and/or P1251 and other DTCs | B |
A
B
Check the intake and exhaust systems modifications.
No modifications.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the vacuum hoses of turbocharger system connections.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the turbocharger sub-assembly (Click here Engine / Hybrid System>N04C-UH (INTAKE)>INTAKE SYSTEM>ON-VEHICLE INSPECTION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the EGR valve assembly (Click here Engine / Hybrid System>N04C-UH (EMISSION CONTROL)>EGR VALVE>INSPECTION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the mass air flow meter sub-assembly (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>MASS AIR FLOW METER>ON-VEHICLE INSPECTION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG