Home › Engine / Hybrid System › N04C-VL (ENGINE CONTROL) › ECD SYSTEM
RM2850E _51 Engine / Hybrid System _073159 N04C-VL ENGINE CONTROL _0357053 ECD SYSTEM L

N04C-VL ENGINE CONTROL  ECD SYSTEM  PRECAUTION  


NOTICE:
·

When the ECM and other component(s) are replaced, perform the following items by following the instructions shown on the GTS display.

Replacement part Item
ECM Input Injector Compensation Code (Click here(Click here))
Supply Pump Initialization (Click here(Click here))
Venturi Assembly Initialization (Click here(Click here))
Injector Assembly Input Injector Compensation Code (Click here(Click here))
·

Suction Control Valve

·

Injection or Supply Pump Assembly


Supply Pump Initialization (Click here(Click here))

·

When disconnecting the negative (-) battery terminal, perform the venturi assembly initialization after the terminal is reconnected (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).



INJECTOR COMPENSATION CODE


HINT:
·

Each injector assembly has different fuel injection characteristics. In order to optimize fuel injection performance, the ECM compensates for these differences by adjusting the fuel injection duration of each injector assembly according to its compensation code. Injector compensation codes are printed on the head portion of each injector assembly.

·

If an incorrect injector compensation code is input into the ECM, the engine may rattle or engine idling may become rough. In addition, engine failure may occur and the life of the engine may be shortened.



a.
A288762E06
2,1.771 2.167,1.771 2.167,1.771 2.594,0.771 true 0.083,0.104 0.396,0.302 0.313,0.198 10 false *a 1.781,1.688 2.094,1.885 0.313,0.198 10 false *b

When an injector assembly is replaced, a new injector's compensation code must be input into the ECM (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION).

NOTICE:

Although some injectors are marked with a 32-digit alphanumeric value, only the first 30 digits must be input.



b.

When the ECM is replaced, all of the existing injector compensation codes must be input into the new ECM (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION).

Text in Illustration
*a Example
*b Injection Compensation Code



DIFFICULT TO START ENGINE, ENGINE STALLING, BLACK SMOKE EMITTED, ROUGH IDLING, EXCESSIVE ENGINE VIBRATION, ENGINE KNOCKING, ENGINE RATTLING, LACK OF POWER OR HESITATION


a.

Check if the customer's problem is described below. If so, refer to the troubleshooting section on the page given.



iii.

There is rough idling or excessive engine vibrations (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>Rough Idling or Excessive Engine Vibrations).






WHEN USING GTS


CAUTION:

Observe the following items for safety reasons:

·

Before using the GTS, read its instruction manual.

·

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes using the GTS, two persons are required. One is for driving the vehicle, and the other operates the GTS.