Home › Brake › BRAKE › BRAKE BOOSTER(for 2AZ-FE LHD) › from 2016.05
RM24M0E _54 Brake _059558 BRAKE _0291882 BRAKE BOOSTER(for 2AZ-FE LHD) A

BRAKE  BRAKE BOOSTER(for 2AZ-FE LHD)  INSTALLATION  


PROCEDURE

Hide 44696 1.INSTALL CHECK VALVE GROMMET

a.

Install the grommet to the booster.


Hide 44730 2.INSTALL BRAKE VACUUM CHECK VALVE ASSEMBLY

a.

Install the check valve to the grommet.


Hide 44785 3.INSTALL BRAKE BOOSTER GASKET

a.

Install a new gasket to the booster.


Hide 47264D 4.INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Install the push rod clevis to the booster.


b.

Temporarily tighten the push rod clevis lock nut.

HINT:

The push rod clevis lock nut will be tightened to a torque specification in the "CHECK AND ADJUST BRAKE PEDAL HEIGHT" procedures.



Hide 44610 5.INSTALL BRAKE BOOSTER ASSEMBLY

a.
C158086

Install the booster with the 4 nuts.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


Hide 47264A 6.INSTALL PUSH ROD PIN

a.
C352603

Apply lithium soap base glycol grease to the push rod pin.

Text in Illustration
V100135

Lithium soap base glycol grease


b.

Install the push rod pin to the push rod clevis.

NOTICE:

The push rod pin must be installed as shown in the illustration.



c.

Install a new clip to the push rod pin.

NOTICE:

The clip must be installed as shown in the illustration.


HINT:

Only the clips in the illustration will be supplied.



Hide 7.CONNECT VACUUM HOSE

a.

Connect the vacuum hose to the check valve.


Hide 47201 8.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 9.BLEED BRAKE SYSTEM

Hide 10.INSPECT AND ADJUST BRAKE PEDAL

Hide 17700 11.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 17705 12.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 74431 13.INSTALL BATTERY TRAY

Hide 15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).