46200
1.INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY
Install the parking brake control pedal (with the No. 1 parking brake cable) with the 4 nuts.
46410
2.CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY
Connect the No. 1 parking brake cable to the parking brake equalizer.
Connect the inner guide of the No. 1 parking brake cable to the crossmember.
Securely install the inner guide to the crossmember.
Install a new clip to fix the cable in place.
for LHD:
Install the 4 bolts.
for RHD:
Install the 3 bolts.
3.TEMPORARILY TIGHTEN LOCK NUT
for Single Nut Type:
Install a new self-lock nut.
The self-lock nut will be tightened to a torque specification in the "ADJUST PARKING BRAKE PEDAL TRAVEL" procedures.
for Double Nut Type:
Install the No. 1 wire adjusting nut and lock nut.
The lock nut will be tightened to a torque specification in the "ADJUST PARKING BRAKE PEDAL TRAVEL" procedures.
4.CONNECT PARKING BRAKE SWITCH CONNECTOR
58810J
5.INSTALL CONSOLE BOX ASSEMBLY
Install the console box (see page Vehicle Interior>INTERIOR>REAR CONSOLE BOX>INSTALLATION).
6.INSTALL FRONT SEAT ASSEMBLY LH (for LHD)
for Manual Seat:
Install the front seat LH (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION).
for Power Seat:
Install the front seat LH (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION).
7.INSTALL FRONT SEAT ASSEMBLY RH (for RHD)
for Manual Seat:
Install the front seat RH (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION).
for Power Seat:
Install the front seat RH (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION).
8.CHECK PARKING BRAKE PEDAL TRAVEL
9.REMOVE REAR WHEEL
10.ADJUST PARKING BRAKE SHOE CLEARANCE
11.INSTALL REAR WHEEL
T = 103 N*m{ 1,050 kgf*cm 76 ft.*lbf }
12.ADJUST PARKING BRAKE PEDAL TRAVEL
55312
13.INSTALL LOWER INSTRUMENT PANEL
Install the lower instrument panel (see page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>INSTALLATION).
55302A
14.INSTALL UPPER INSTRUMENT PANEL
Install the upper instrument panel (see page Vehicle Interior>INTERIOR PANEL>UPPER INSTRUMENT PANEL>INSTALLATION).
15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).