Home › Steering › POWER STEERING › POWER STEERING SYSTEM › from 2016.05
RM24M0E _55 Steering _059561 POWER STEERING _0291895 POWER STEERING SYSTEM G

POWER STEERING  POWER STEERING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. CHECK STEERING EFFORT (TORQUE)

NOTICE:

Some service operations affect the SRS airbags. Be sure to read the precautionary notice for the SRS airbags before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


a.

Stop the vehicle on a level, paved surface and align the wheels straight ahead.


b.

Disconnect the negative (-) battery cable from the battery (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


c.

d.

e.

Connect the negative (-) battery cable to the battery.


f.

Using a torque wrench, check if the steering wheel set nut is properly tightened.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


g.

Start the engine so that the power steering is ready to operate.


h.
C132536

Turn the steering wheel 90° to the right and check the steering effort (torque) while turning. Check in the opposite direction using the same method.

Standard steering effort (Reference):

6.9 N*m (70 kgf*cm, 61 in.*lbf) or less



i.

Align the front wheels straight ahead.


j.

Turn the engine switch off.


k.

Disconnect the negative (-) battery cable from the battery.




n.

Connect the negative (-) battery cable to the battery.



p.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).