When an incorrect ECM or an incorrect skid control ECU (brake actuator assembly) is installed after the assist map has been recorded in the power steering ECU, then DTC C1582 is stored because the data does not match the vehicle specifications.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1582 | Assist map number mismatch | ·
Power steering ECU ·
CAN communication system ·
ECM ·
Skid control ECU (brake actuator assembly) |
If the steering column or power steering ECU has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (See page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).
Using the intelligent tester, check for DTCs and confirm that there are no problems in the CAN communication system (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).
DTC is not output.
OK
NG
Check if an ECM that complies with the vehicle specifications is installed.
The ECM that complies with vehicle specifications is installed.
OK
NG
Check if a skid control ECU (brake actuator assembly) that complies with the vehicle specifications is installed.
The skid control ECU (brake actuator assembly) that complies with vehicle specifications is installed.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 2AZ-FE without VSC) | B |
| NG (for 2AZ-FE with VSC) | C |
| NG (for 2GR-FE) | D |
A
B
(See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR(for 2AZ-FE without VSC)>REMOVAL)
C
D