Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291902 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 73960A 1.INSTALL FRONT PASSENGER AIRBAG ASSEMBLY

a.

Attach the rear side hook of the front passenger airbag to the rear side airbag door.


b.

Bend the front side hook so that it attaches to the front side airbag door.


c.
C139026

Install the 2 bolts to No. 3 heater to register duct.


Hide 3.CONNECT FRONT PASSENGER AIRBAG CONNECTOR

a.
C367468

Connect the connector to the airbag.

NOTICE:

When handling the airbag connector, do not damage the airbag wire harness.



Hide 55550 4.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 62212 5.INSTALL FRONT PILLAR GARNISH LH (w/ Curtain Shield Airbag)

Hide 62212 6.INSTALL FRONT PILLAR GARNISH LH (w/o Curtain Shield Airbag)

Hide 62226 7.INSTALL FRONT PILLAR GARNISH LOWER LH

Hide 62211 8.INSTALL FRONT PILLAR GARNISH RH (w/ Curtain Shield Airbag)

Hide 62211 9.INSTALL FRONT PILLAR GARNISH RH (w/o Curtain Shield Airbag)

Hide 62225A 10.INSTALL FRONT PILLAR GARNISH LOWER RH

Hide 55042B 11.INSTALL NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

Hide 55660 12.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55041B 13.INSTALL NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

Hide 55650 14.INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55522B 15.INSTALL RADIO TUNER OPENING COVER (w/o Radio Receiver)

Hide 16.INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)

Hide 17.INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type)

Hide 55414A 18.INSTALL INSTRUMENT CLUSTER FINISH PANEL END (w/o Navigation System)

Hide 55420A 19.INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY

Hide 84306 20.INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE

Hide 45100 22.INSTALL STEERING WHEEL ASSEMBLY

Hide 45186 24.INSTALL NO. 2 STEERING WHEEL COVER LOWER

Hide 45187 25.INSTALL NO. 3 STEERING WHEEL COVER LOWER

Hide 55404C 26.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55042B 27.INSTALL NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

Hide 28800 28.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 29.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



Hide 30.CHECK SRS WARNING LIGHT