1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See Page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45186
2.REMOVE NO. 2 STEERING WHEEL LOWER COVER
45187
3.REMOVE NO. 3 STEERING WHEEL LOWER COVER
45130
4.REMOVE STEERING PAD ASSEMBLY
5. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
45100
6.REMOVE STEERING WHEEL ASSEMBLY
45286
7.REMOVE STEERING COLUMN COVER
55420A
8.REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY
55414A
9.REMOVE INSTRUMENT CLUSTER FINISH PANEL END (w/o Navigation System)
10.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)
55650
11.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY
55041B
12.REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY
55660
13.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
55042B
14.REMOVE NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY
55550
15.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
33504F
16.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
67914B
17.REMOVE FRONT DOOR SCUFF PLATE LH
67913B
18.REMOVE FRONT DOOR SCUFF PLATE RH
62112
19.REMOVE COWL SIDE TRIM BOARD LH
62111C
20.REMOVE COWL SIDE TRIM BOARD RH
55474B
21.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH
55447C
22.REMOVE NO. 1 SWITCH HOLE BASE
55606
23.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55432B
24.REMOVE INSTRUMENT PANEL FINISH PANEL LOWER (w/ Knee Airbag)
55432B
25.REMOVE INSTRUMENT PANEL FINISH PANEL LOWER (w/o Knee Airbag)
58534E
26.REMOVE FLOOR CARPET COVER CENTER LH
58533C
27.REMOVE FLOOR CARPET COVER CENTER RH
55434B
28.REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER
55433B
29.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL LOWER
55900A
30.REMOVE HEATER CONTROL AND ACCESSORY
33820B
31.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Disconnect the control cable from the shift lever.
Using a screwdriver, pull out the stopper of the transmission control cable.
Do not remove the stopper. If the stopper is removed, reinstall it to its original position.
| *a | Nut |
| *b | Stopper |
Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.
Do not over-rotate the nut as it will come off the interior spring and the transmission control cable will not be reusable.
32.REMOVE SHIFT LEVER ASSEMBLY
Remove the 4 bolts, screw and shift lever.
Disconnect the 2 connectors.