Home › Drivetrain › AXLE › FRONT AXLE HUB › from 2016.05
RM24M0E _52 Drivetrain _059581 AXLE _0292138 FRONT AXLE HUB A

AXLE  FRONT AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DRAIN AUTOMATIC TRANSAXLE FLUID (for 2AZ-FE, Automatic Transaxle)

Hide 4.DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID (for CVT)

Hide 5.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See Page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 43502H 6.REMOVE FRONT AXLE HUB NUT

a.
C136799E02
2.37,1.236 2.37,0.679 false 2.364,0.677 2.475,0.677 false 2.485,0.599 2.772,0.741 0.288,0.142 10 SST

Using SST and a hammer, unstake the staked part of the nut.

SST
09930-00010  

NOTICE:

Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged.



b.

While applying the brakes, remove the lock axle hub nut.


Hide 47750 8.REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY LH

a.
C130484

Remove the 2 bolts and caliper.


Hide 43512 9.REMOVE FRONT DISC (for 16 inch Front Disc Brake)

Hide 43512 10.REMOVE FRONT DISC (for 17 inch Front Disc Brake)

Hide 45407 11.DISCONNECT TIE ROD END SUB-ASSEMBLY LH

Hide 48069 12.DISCONNECT FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY LH

C136800

a.

Remove the bolt and 2 nuts.


b.

Disconnect the lower arm from the ball joint.


Hide 13.REMOVE STEERING KNUCKLE WITH AXLE HUB

C136801

a.

Remove the 2 bolts and 2 nuts, and disconnect the shock absorber from the steering knuckle.

HINT:

While fixing the nuts in place, loosen and remove the bolts.



b.
C160201E03
1.698,1.198 2.375,0.938 2.375,0.938 1.833,1.292 true 2.417,0.833 3.188,0.99 0.771,0.156 10 false Matchmark

Put matchmarks on the drive shaft and the axle hub.


c.

Using a plastic-faced hammer, remove the steering knuckle with axle hub.

NOTICE:

Be careful not to damage the boot and speed sensor rotor. Do not excessively push out the drive shaft from the axle assembly.



Hide 43340A 14.REMOVE FRONT LOWER BALL JOINT ASSEMBLY LH

Hide 43502C 15.REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH

C136803

a.

Remove the 4 bolts and axle hub from the steering knuckle.

NOTICE:

Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.



b.

Remove the dust cover from the steering knuckle.