Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2013.04–2014.09
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292157 ANTI-LOCK BRAKE SYSTEM T

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



NOTICE:

When replacing the brake actuator or sensor, turn the engine switch off.


Anti-lock brake system:
Symptom Suspected Area See page
ABS and / or EBD does not operate 1. Check for DTCs again and make sure that normal system code is displayed. (Click here)
2. IG power source circuit (Click here)
3. Front speed sensor circuit (Click here)
4. Rear speed sensor circuit (Click here)
5. Check brake actuator using intelligent tester. (Check brake actuator operation using Active Test function.) If abnormal, check hydraulic circuit for leakage. (Click here)
6. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator (skid control ECU). (Click here)
ABS and / or EBD does not operate efficiently 1. Check for DTCs again and make sure that normal system code is displayed. (Click here)
2. Front speed sensor circuit (Click here)
3. Rear speed sensor circuit (Click here)
4. Stop light switch circuit (Click here)
5. Check brake actuator using intelligent tester. (Check brake actuator operation using Active Test function.) If abnormal, check hydraulic circuit for leakage. (Click here)
6. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator (skid control ECU). (Click here)
Sensor signal check cannot be performed 1. TS and CG terminal circuit (Click here)
2. Brake actuator (skid control ECU) (Click here)
DTC check cannot be performed 1. Check for DTCs again and make sure that normal system code is displayed. (Click here)
2. TC and CG terminal circuit (Click here)
3. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator (skid control ECU). (Click here)
ABS warning light abnormal (Remains on) 1. ABS warning light circuit (Click here)
2. Brake actuator (skid control ECU) (Click here)
ABS warning light abnormal (Does not come on) 1. ABS warning light circuit (Click here)
2. Brake actuator (skid control ECU) (Click here)
Brake warning light abnormal (Remains on) 1. Brake warning light circuit (Click here)
2. Brake actuator (skid control ECU) (Click here)
Brake warning light abnormal (Does not come on) 1. Brake warning light circuit (Click here)
2. Brake actuator (skid control ECU) (Click here)