PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Aug 2009 – Oct 2010
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| Open in CAN Main Wire |
CAN Main Wire for Disconnection |
Click here
|
| Short in CAN Bus Line |
Check CAN Bus Lines for Short Circuit |
Click here
|
| Short to +B in CAN Bus Line |
Check CAN Bus line for Short to +B |
Click here
|
| Short to GND in CAN Bus Line |
Check CAN Bus line for Short to GND |
Click here
|
| Open in One Side of CAN Branch Wire |
Open in One Side of the CAN Branch Wire |
Click here
|
| Symptom |
Suspected Area |
See page |
| "Engine" not displayed on intelligent tester |
ECM Communication Stop Mode |
Click here
|
| "ABS/VSC/TRC" not displayed on intelligent tester |
Skid Control ECU Communication Stop Mode |
Click here
|
| "Steering Angle Sensor" not displayed on intelligent tester |
Steering Angle Sensor Communication Stop Mode |
Click here
|
| "Yaw Rate / Deceleration Sensor" not displayed on intelligent tester |
Yaw Rate Sensor Communication Stop Mode |
Click here
|