VC Output Circuit
Circuit diagnosis · Vehicles built Nov 2010 – Jul 2014
Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2014 from Aug 2014
DESCRIPTION
The ECM constantly generates 5 V power from the battery voltage supplied to the +B (BATT) terminal to operate the microprocessor. The ECM also provides this power to the sensors through the VC output circuit.

When the VC circuit is short-circuited, the microprocessor in the ECM and sensors that are supplied power through the VC circuit are inactivated because the power is not supplied from the VC circuit. Under this condition, the system does not start up and the MIL does not illuminate even if the system malfunctions.
- HINT:
- Under normal conditions, the MIL is illuminated for several seconds when the ignition switch is first turned ON. The MIL goes off when the engine is started.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK MIL |
Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch to ON.
- OK:
- MIL lights up
|
|
||||
| OK | ||
| ||
| 2. CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Check the communication between the intelligent tester and ECM.
Result Result
Proceed to
Communication is not possible
A
Communication is possible
B
|
|
||||
| A | |
| 3. CHECK MIL (THROTTLE WITH MOTOR BODY ASSEMBLY) |
Disconnect the throttle with motor body assembly connector.
Turn the ignition switch to ON.
Check the MIL.
Result Result
Proceed to
MIL does not illuminate
A
MIL illuminates
B
|
|
||||
| A | |
| 4. CHECK MIL (ACCELERATOR PEDAL ROD ASSEMBLY) |
Disconnect the accelerator pedal connector.
Turn the ignition switch to ON.
Check the MIL.
Result Result
Proceed to
MIL does not illuminate
A
MIL illuminates
B
|
|
||||
| A | |
| 5. CHECK MIL (VVT SENSOR (FOR INTAKE SIDE OF BANK 1)) |
Disconnect the VVT sensor (for intake side of bank 1) connector.
Turn the ignition switch to ON.
Check the MIL.
Result Result
Proceed to
MIL does not illuminate
A
MIL illuminates
B
|
|
||||
| A | |
| 6. CHECK MIL (VVT SENSOR (FOR INTAKE SIDE OF BANK 2)) |
Disconnect the VVT sensor (for intake side of bank 2) connector.
Turn the ignition switch to ON.
Check the MIL.
Result Result
Proceed to
MIL does not illuminate
A
MIL illuminates
B
|
|
||||
| A | |
| 7. CHECK MIL (VVT SENSOR (FOR EXHAUST SIDE OF BANK 1)) |
Disconnect the VVT sensor (for exhaust side of bank 1) connector.
Turn the ignition switch to ON.
Check the MIL.
Result Result
Proceed to
MIL does not illuminate
A
MIL illuminates
B
|
|
||||
| A | |
| 8. CHECK MIL (VVT SENSOR (FOR EXHAUST SIDE OF BANK 2)) |
Disconnect the VVT sensor (for exhaust side of bank 2) connector.
Turn the ignition switch to ON.
Check the MIL.
Result Result
Proceed to
MIL does not illuminate
A
MIL illuminates
B
|
|
||||
| A | |
| 9. CHECK MIL (POWER STEERING OIL PRESSURE SWITCH) |
Disconnect the power steering oil pressure switch (sensor) connector.
Turn the ignition switch to ON.
Check the MIL.
Result Result
Proceed to
MIL does not illuminate
A
MIL illuminates
B
|
|
||||
| A | |
| 10. CHECK HARNESS AND CONNECTOR |
Disconnect the throttle with motor body assembly connector.
Disconnect the accelerator pedal rod assembly connector.
Disconnect the VVT sensor (for intake side of bank 1) connector.
Disconnect the VVT sensor (for intake side of bank 2) connector.
Disconnect the VVT sensor (for exhaust side of bank 1) connector.
Disconnect the VVT sensor (for exhaust side of bank 2) connector.
Disconnect the power steering oil pressure switch (sensor) connector.
Disconnect the ECM connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance (check for short):
Tester Connection
Condition
Specified Condition
B47-15 (VCV1) - Body ground
Always
10 kΩ or higher
B47-16 (VCV2) - Body ground
Always
10 kΩ or higher
E81-4 (VCPA) - Body ground
Always
10 kΩ or higher
E81-2 (VCP2) - Body ground
Always
10 kΩ or higher
B49-13 (VCTA) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
