2011-2016 FJ Cruiser · Service Manual BRAKE

A-TRAC Indicator Light does not Come ON

Circuit diagnosis · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012

DESCRIPTION

Click here.

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK A-TRAC INDICATOR LIGHT

  1. C121700E75
    Disconnect the skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Ground terminal HDCW of the skid control ECU.

  1. Check the A-TRAC indicator light.

    OK:
    HDCW - GND Condition
    Illumination Condition
    Connecting
    ON
    Disconnecting
    OFF



NG
Go to step 2
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)

2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)

  1. C135294E05
    Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    A4-33 (HDCW) - E14-9 (ATRA)
    Below 1 Ω
    A4-33 (HDCW) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

    OK:
    Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← A-TRAC Indicator Light Remains ON (from Nov 2012)A-TRAC Indicator Light does not Come ON (Aug 2009 – Oct 2010) →