A-TRAC Indicator Light does not Come ON
Circuit diagnosis · Vehicles built Aug 2009 – Oct 2010
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012
DESCRIPTION
Click here.WIRING DIAGRAM
Click here.INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. CHECK A-TRAC INDICATOR LIGHT |
 |
- Disconnect the skid control ECU connector.
Turn the ignition switch to ON.
Ground terminal HDCW of the skid control ECU.
Check the A-TRAC indicator light.
- OK:
HDCW - GND Condition
|
Illumination Condition
|
Connecting
|
ON
|
Disconnecting
|
OFF
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
|
| 2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER) |
 |
- Disconnect the skid control ECU connector.
Disconnect the combination meter connector.
Measure the resistance.
- Standard resistance:
Tester Connection
|
Specified Condition
|
A4-33 (HDCW) - E14-9 (ATRA)
|
Below 1 Ω
|
A4-33 (HDCW) - Body ground
|
10 kΩ or higher
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 3. INSPECT COMBINATION METER ASSEMBLY |
 |
Check the combination meter system (Click here).
- OK:
- Combination meter is normal.
|
NG |
 |
|
|
|
| OK |
|
 |
|
|