Home › Engine / Hybrid System › A25A-FXS, A25B-FXS (FUEL) › FUEL PRESSURE SENSOR › from 2020.11
RM37A0E _51 Engine / Hybrid System _086907 A25A-FXS, A25B-FXS FUEL _0417785 FUEL PRESSURE SENSOR A

A25A-FXS, A25B-FXS FUEL  FUEL PRESSURE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89458H 1.INSTALL NO. 2 FUEL PRESSURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.

Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Install a new O-ring to the No. 2 fuel pressure sensor.


b.
A423451C01
2.594,2.667 2.594,2.906 false 0.719,2.708 0.719,2.948 false 0.979,2.719 0.979,2.958 true 2.063,2.729 2.063,2.969 true 0.656,2.948 0.969,3.146 0.313,0.198 10 false *1 2.542,2.906 2.771,3.167 0.229,0.26 10 false *2 0.917,2.958 1.229,3.156 0.313,0.198 10 false *a 2,2.958 2.313,3.156 0.313,0.198 10 false *a
*1 No. 2 Fuel Pressure Sensor
*2 No. 2 Fuel Pressure Sensor Holder
*a Flat


Install the No. 2 fuel pressure sensor holder to the No. 2 fuel pressure sensor as shown in the illustration.


c.

Using an 8 mm socket wrench, install the No. 2 fuel pressure sensor with the No. 2 fuel pressure sensor holder to the fuel delivery pipe sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Connect the No. 2 fuel pressure sensor connector.


Hide 23100X 2.TEMPORARILY INSTALL FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY

Hide 23801P 3.TEMPORARILY INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY

Hide 23100X 4.INSTALL FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY

Hide 25715 8.INSTALL EMISSION CONTROL VALVE BRACKET (w/ Differential Pressure Sensor)

Hide 22030 10.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 11.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 58441L 12.INSTALL BATTERY SERVICE HOLE COVER

Hide 14.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.

Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION