Home › General › MAINTENANCE › CHASSIS › 2011.10–2012.04
RM1840EF _V1 General _009567 MAINTENANCE _0052054 CHASSIS N

MAINTENANCE  CHASSIS  GENERAL MAINTENANCE  


PROCEDURE

Hide 1.INSPECT POWER STEERING FLUID

a.

Hide 2.INSPECT STEERING LINKAGE AND GEAR HOUSING

a.

Check the steering wheel free play.


b.

Check the steering linkage for looseness or damage.

i.

Check that the tie rod ends do not have excessive play.


ii.

Check that the dust seals and boots are not damaged.


iii.

Check that the boot clamps are not loose.


iv.

Check that the steering gear housing is not damaged.


v.

Check that the connectors are properly connected to the steering gear housing.



Hide 3.LUBRICATE PROPELLER SHAFT AND TIGHTEN BOLTS (for TASA Made)

a.

Lubricate the propeller shaft by referring to the lubrication chart. Before pumping in grease, wipe off any mud and dust on the grease fitting.

Type See procedure
for Front (Click here)
for Rear (Click here)


b.

Tighten the bolts of the propeller shaft.

Type See procedure
for Front (Click here)
for Pre-Runner (Click here)
for 4WD (Click here)


Hide 4.LUBRICATE PROPELLER SHAFT AND TIGHTEN BOLTS (for TMT Made)

a.

Lubricate the propeller shaft by referring to the lubrication chart. Before pumping in grease, wipe off any mud and dust on the grease fitting.

Type See procedure
for Front (Click here)
for Rear (Click here)


b.

Tighten the bolts of the propeller shaft.

Type See procedure
for Front (Click here)
for Pre-Runner (Click here)
for 4WD (Click here)


Hide 5.INSPECT DRIVE SHAFT BOOTS (for 4WD)

a.

Check the drive shaft boots for loose clamps, grease leakage, kinks or damage.


Hide 6.INSPECT BALL JOINTS AND DUST COVERS

a.

Inspect the ball joints for excessive looseness.

i.

Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.


ii.

Lower the vehicle until the front coil spring has about half its ordinary load. Place stands under the vehicle for safety.


iii.

Check that the front wheels are pointing straight ahead. Use wheel chocks on all 4 wheels.


iv.

Using a lever, pry up the end of the lower arm. Check the amount of play.

Maximum ball joint vertical play:

0 mm (0 in.)


If there is any play, replace the ball joint.



b.

Check the dust cover for damage.


Hide 7.INSPECT MANUAL TRANSMISSION OIL

Type See procedure
R150, R151 (Click here)
R150F, R151F, R156F (Click here)

Hide 8.REPLACE MANUAL TRANSMISSION OIL

Type See procedure
R150, R151 (Click here)
R150F, R151F, R156F (Click here)

Hide 9.INSPECT AUTOMATIC TRANSMISSION FLUID

Type See procedure
A343E (Click here)
A340F (Click here)
A343F (Click here)

Hide 10.REPLACE AUTOMATIC TRANSMISSION FLUID

Type See procedure
A343E (Click here)
A340F (Click here)
A343F (Click here)

Hide 11.INSPECT TRANSFER OIL

Hide 12.REPLACE TRANSFER OIL

a.

Hide 13.INSPECT FRONT DIFFERENTIAL OIL

a.

Inspect the front differential oil (See page Drivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL OIL>REPLACEMENT).


Hide 14.REPLACE FRONT DIFFERENTIAL OIL

a.

Replace the front differential oil (See page Drivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL OIL>REPLACEMENT).


Hide 15.INSPECT REAR DIFFERENTIAL OIL

a.

Inspect the rear differential oil (See page Drivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL OIL>REPLACEMENT).


Hide 16.REPLACE REAR DIFFERENTIAL OIL

a.

Replace the rear differential oil (See page Drivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL OIL>REPLACEMENT).


Hide 17.INSPECT FRONT AND REAR SUSPENSION

Type See procedure
Front (Click here)
Rear (Click here)