CYLINDER HEAD > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
| 4. DRAIN ENGINE COOLANT |
![]() |
Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.
Loosen the cylinder block drain cock plug and the radiator drain cock plug.

| 5. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Wipe the oil pan and drain plug.
Install a new gasket and the oil pan drain plug.
| 6. REMOVE INTAKE MANIFOLD |
| 7. REMOVE GLOW PLUG ASSEMBLY |
| 8. REMOVE INJECTOR ASSEMBLY |
| 9. REMOVE COMMON RAIL ASSEMBLY |
| 10. REMOVE TURBOCHARGER SUB-ASSEMBLY |
| 11. REMOVE FAN SHROUD |
| 12. DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System) |
Remove the 4 bolts and disconnect the cooler compressor.
| 13. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET (w/ Air Conditioning System) |
Remove the 4 bolts and No. 1 compressor mounting bracket.
| 14. REMOVE EXHAUST MANIFOLD |
![]() |
Remove the 8 nuts, 8 plate washers, 8 collars and exhaust manifold.
Remove the gasket.
| 15. REMOVE TIMING BELT |
| 16. REMOVE CAMSHAFT TIMING PULLEY |
![]() |
Remove the bolt of the camshaft timing pulley while holding the camshaft with a wrench.
Remove the camshaft timing pulley.
| 17. REMOVE NO. 2 TIMING BELT COVER |
Remove the 4 bolts, nut and No. 2 timing belt cover.
| 18. REMOVE CYLINDER BLOCK INSULATOR |
![]() |
Remove the cylinder block insulator from the cylinder head.
| 19. REMOVE CAMSHAFT |
![]() |
Turn the camshaft with a wrench so that the key groove of the camshaft faces upward.
| *1 | Key Groove |
![]() |
Uniformly loosen the 15 bearing cap bolts in several passes in the sequence shown in the illustration.
Remove the 15 bearing cap bolts, 5 bearing caps, oil seal and 2 camshafts.
| 20. REMOVE VALVE LIFTER |
Remove the valve lifters.
| 21. REMOVE CYLINDER HEAD SUB-ASSEMBLY |
![]() |
Uniformly loosen the 18 cylinder head bolts in several passes in the sequence shown in the illustration. Then remove the 18 cylinder head bolts and 18 washers.
Remove the cylinder head from the dowels on the cylinder block and place the cylinder head on wooden blocks on a workbench.
| 22. REMOVE CYLINDER HEAD GASKET |