Perform these procedures after the engine has cooled down.
1.INSPECT TIMING BELT
3.INSPECT TIMING BELT PULLEY
4.CLEAN TIMING BELT COVER (for 1KD-FTV)
This is for vehicles often used in excessively dusty conditions. Inspect for cracks on the timing belt or abnormal wear on the timing pulley. Then, remove sand and dust in the timing belt cover.
Remove the timing belt cover.
Check that the timing belt cover is not dirty.
If cleaning a timing belt cover, blow compressed air to clean it.
Reinstall the timing belt cover.
7.REPLACE ENGINE OIL AND OIL FILTER
8.INSPECT COOLING AND HEATER SYSTEM
Check that the radiator, condenser and/or intercooler is not blocked with leaves, dirt or insects, and clean them if necessary. Also check the hose connection for the installation condition, corrosion, etc.
11.INSPECT ENGINE OIL COOLER HOSES AND CONNECTIONS (for 1GR-FE)
Check the oil cooler hoses for cracks, leakage, loose connections and deformation.
12.INSPECT EXHAUST PIPES AND MOUNTINGS
Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.
13.REPLACE DPR HOSE (w/ DPF)
15.INSPECT BATTERY ELECTROLYTE LEVEL
17.REPLACE FUEL SENDER GAUGE (for 2TR-FBE)
Replace fuel sender gauge assembly.
Click hereEngine / Hybrid System>2TR-FBE FUEL>FUEL SENDER GAUGE ASSEMBLY>REMOVAL
18.CLEAN FUEL PUMP SUCTION FILTER (for 2TR-FBE)
Remove the fuel suction with pump and gauge tube assembly.
Click hereEngine / Hybrid System>2TR-FBE FUEL>FUEL PUMP>REMOVAL
| *A | Example |
| *a | CORRECT |
| *b | INCORRECT |
While keeping the air gun parallel to the face of the suction filter, blow compressed air to clean the suction filter.
Do not blow compressed air directly onto the face of the suction filter, as this will only make clogs worse.
19.REPLACE FUEL FILTER
20.INSPECT AIR CLEANER FILTER
21.INSPECT FUEL TANK CAP GASKET
22.INSPECT FUEL LINES, FUEL LINE CONNECTIONS, FUEL TANK VAPOR VENT SYSTEM HOSES AND FUEL TANK BAND
Visually check the fuel lines and hoses for cracks, leakage, loose connections and deformation. Also, visually check the tank band for looseness.