PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- NOTICE:
- When replacing the brake actuator assembly, sensor, etc., turn the ignition switch off.
| Symptom |
Suspected Area |
See page |
| ABS, BA and/or EBD does not operate |
Check for DTCs again and make sure that normal system code is output |
Click here
|
| IG power source circuit (low power supply voltage malfunction) |
Click here
|
|
| IG power source circuit (high power supply voltage malfunction) |
Click here
|
|
| Front speed sensor circuit (comparison malfunction) |
Click here
|
|
| Front speed sensor circuit (open or short malfunction) |
Click here
|
|
| Front speed sensor circuit (output malfunction) |
Click here
|
|
| Rear speed sensor circuit (comparison malfunction) |
Click here
|
|
| Rear speed sensor circuit (open or short malfunction) |
Click here
|
|
| Rear speed sensor circuit (output malfunction) |
Click here
|
|
| Check brake actuator assembly with intelligent tester (check brake actuator assembly operation using Active Test function). If abnormal, check hydraulic circuit for leaks. |
Click here
|
|
| If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU) |
Click here
|
|
| ABS, BA and/or EBD does not operate efficiently |
Check for DTCs again and make sure that normal system code is output |
Click here
|
| Front speed sensor circuit (comparison malfunction) |
Click here
|
|
| Front speed sensor circuit (open or short malfunction) |
Click here
|
|
| Front speed sensor circuit (output malfunction) |
Click here
|
|
| Rear speed sensor circuit (comparison malfunction) |
Click here
|
|
| Rear speed sensor circuit (open or short malfunction) |
Click here
|
|
| Rear speed sensor circuit (output malfunction) |
Click here
|
|
| Stop light switch circuit |
Click here
|
|
| Check brake actuator assembly with the intelligent tester (check brake actuator assembly operation using Active Test function). If abnormal, check hydraulic circuit for leaks. |
Click here
|
|
| If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU) |
Click here
|
|
| ABS warning light abnormal (Remains on) |
ABS warning light circuit |
Click here
|
| IG power source circuit (High power supply voltage malfunction) |
Click here
|
|
| Brake actuator assembly (skid control ECU) |
Click here
|
|
| ABS warning light abnormal (Does not come on) |
ABS warning light circuit |
Click here
|
| Brake actuator assembly (skid control ECU) |
Click here
|
|
| Brake warning light abnormal (Remains on) |
Brake warning light circuit |
Click here
|
| IG power source circuit (High power supply voltage malfunction) |
Click here
|
|
| Brake actuator assembly (skid control ECU) |
Click here
|
|
| Brake warning light abnormal (Does not come on) |
Brake warning light circuit |
Click here
|
| Brake actuator assembly (skid control ECU) |
Click here
|
|
| VSC and/or TRC does not operate |
Check for DTCs again and make sure that normal system code is output |
Click here
|
| IG power source circuit (low power supply voltage malfunction) |
Click here
|
|
| IG power source circuit (high power supply voltage malfunction) |
Click here
|
|
| Check hydraulic circuit for leaks |
- |
|
| Front speed sensor circuit (comparison malfunction) |
Click here
|
|
| Front speed sensor circuit (open or short malfunction) |
Click here
|
|
| Front speed sensor circuit (output malfunction) |
Click here
|
|
| Rear speed sensor circuit (comparison malfunction) |
Click here
|
|
| Rear speed sensor circuit (open or short malfunction) |
Click here
|
|
| Rear speed sensor circuit (output malfunction) |
Click here
|
|
| Yaw rate and acceleration sensor circuit (zero point malfunction) |
Click here
|
|
| Yaw rate and acceleration sensor circuit (power supply malfunction) |
Click here
|
|
| Acceleration sensor circuit (comparison malfunction) |
Click here
|
|
| Yaw rate sensor circuit (comparison malfunction) |
Click here
|
|
| Yaw rate and acceleration sensor circuit (stuck or output malfunction) |
Click here
|
|
| Yaw rate and acceleration sensor circuit (internal malfunction) |
Click here
|
|
| Steering angle sensor circuit (zero point malfunction) |
Click here
|
|
| Steering angle sensor circuit (power supply malfunction) |
Click here
|
|
| Steering angle sensor circuit (output malfunction) |
Click here
|
|
| Steering angle sensor circuit (internal malfunction) |
Click here
|
|
| If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU) |
Click here
|
|
| VSC OFF indicator abnormal (Remains on) |
VSC OFF indicator light circuit |
Click here
|
| Brake actuator assembly (skid control ECU) |
Click here
|
|
| VSC OFF indicator abnormal (Does not come on) |
VSC OFF indicator light circuit |
Click here
|
| Brake actuator assembly (skid control ECU) |
Click here
|
|
| Slip indicator light abnormal (Remains on) |
Slip indicator light circuit |
Click here
|
| IG power source circuit (High power supply voltage malfunction) |
Click here
|
|
| Brake actuator assembly (skid control ECU) |
Click here
|
|
| Slip indicator light abnormal (Does not come on) |
Slip indicator light circuit |
Click here
|
| Brake actuator assembly (skid control ECU) |
Click here
|
|
| TRC OFF indicator light abnormal (Remains on) |
TRC OFF indicator light circuit |
Click here
|
| Brake actuator assembly (skid control ECU) |
Click here
|
|
| TRC OFF indicator light abnormal (Does not come on) |
TRC OFF indicator light circuit |
Click here
|
| Brake actuator assembly (skid control ECU) |
Click here
|
|
| DTC check cannot be performed |
Check for DTCs again and make sure that normal system code is output |
Click here
|
| TC and CG terminal circuit |
Click here
|
|
| IG power source circuit (high power supply voltage malfunction) |
Click here
|
|
| If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU) |
Click here
|
|
| Sensor check cannot be performed |
TS and CG terminal circuit |
Click here
|
| Brake actuator assembly (skid control ECU) |
Click here
|
|
| Buzzer abnormal |
VSC buzzer circuit |
Click here
|