REMOVAL
Removal / installation · Vehicles built from Aug 2013
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- w/ Navigation System (for HDD):
After the engine switch is turned off, the HDD navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the engine switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
- w/ Navigation System (for HDD):
| 2. REMOVE FRONT WHEELS |
| 3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 4 bolts.

Unhook the engine under cover from the vehicle body as shown in the illustration.
| 4. REMOVE TRANSMISSION UNDER COVER (except 5L-E) |
Remove the 2 bolts and transmission under cover.
| 5. REMOVE REAR ENGINE UNDER COVER ASSEMBLY (except 5L-E) |
Remove the 4 bolts and rear engine under cover.
| 6. DRAIN DIFFERENTIAL OIL |
Stop the vehicle on a level surface.
Remove the differential drain plug and gasket.
Drain the oil.
Install a new gasket and the differential drain plug.
- Torque:
- Front differential carrier:
- 65 N*m{ 660 kgf*cm , 48 ft.*lbf }
- Rear differential carrier:
- 49 N*m{ 500 kgf*cm , 36 ft.*lbf }
| 7. REMOVE FRONT PROPELLER SHAFT ASSEMBLY |
Remove the front propeller shaft (Click here).
| 8. REMOVE FRONT DRIVE SHAFT ASSEMBLY |
Remove the front drive shaft (Click here).
| 9. REMOVE FRONT STABILIZER LINK ASSEMBLY |
w/ KDSS:
Remove the stabilizer link (Click here).
w/o KDSS:
Remove the stabilizer link (Click here).
| 10. REMOVE FRONT SPEED SENSOR |
Remove the front speed sensor (Click here).
| 11. DISCONNECT TIE ROD END SUB-ASSEMBLY LH |
Disconnect the tie rod end sub-assembly (Click here).
| 12. DISCONNECT TIE ROD END SUB-ASSEMBLY RH |
Disconnect the tie rod end sub-assembly (Click here).
| 13. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH |
Remove the front lower No. 1 suspension arm sub-assembly (Click here).
| 14. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
| 15. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY |
![]() ![]() |
Remove the bolt and disconnect the front differential breather tube bracket.
Support the front differential with a jack.
Remove the front No. 1 differential mounting nut.
Remove the 2 front mounting bolts and nut.
Text in Illustration *1
Mounting Bolt
*2
Mounting Nut
Disconnect the actuator hose and connector.
Lower the jack and remove the front differential.
Remove the 3 bolts and front No. 1 differential support.

Remove the 2 bolts and front No. 2 differential support.

Remove the 2 bolts and front No. 3 differential support.


