36100
1.INSTALL TRANSFER ASSEMBLY
33107
2.INSTALL TRANSMISSION UPPER COVER SUB-ASSEMBLY
Install the transmission upper cover sub-assembly with the 2 bolts.
3.INSTALL MANUAL TRANSMISSION WITH TRANSFER
Install the manual transmission with transfer with the 9 bolts.
36407
4.CONNECT TRANSFER AND MANUAL TRANSMISSION BREATHER HOSE SUB-ASSEMBLY
Connect the 2 breather hoses to the transfer adapter.
Connect the 4 breather hoses to the bracket and clutch housing.
Attach the breather hose clamp.
5.CONNECT WIRE HARNESS
Connect the wire harness with the bolt.
Attach the 7 clamps.
Connect the 2 connectors.
12371
6.INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR
Install the rear No. 1 engine mounting insulator with the 4 bolts.
12391
7.INSTALL FRONT ENGINE MOUNTING INSULATOR RH
Install the front engine mounting insulator with the bolt.
51204
8.INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
Install the No. 3 frame crossmember sub-assembly with the 4 bolts and 4 nuts.
Install the 4 bolts to the No. 3 frame crossmember sub-assembly.
51226A
9.INSTALL FRONT SUSPENSION MEMBER BRACKET LH
Install the front suspension member bracket LH with the 4 bolts.
51225B
10.INSTALL FRONT SUSPENSION MEMBER BRACKET RH
Install the front suspension member bracket RH with the 4 bolts.
31482
11.INSTALL CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE
Temporarily install the clutch release cylinder to flexible hose tube with the 3 nuts and a new clip.
Tighten the labeled A.
Tighten the labeled B.
31490
12.INSTALL CLUTCH ACCUMULATOR ASSEMBLY
31470
13.INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY
28100
14.INSTALL STARTER ASSEMBLY
37110
15.INSTALL PROPELLER SHAFT ASSEMBLY
37140
16.INSTALL FRONT PROPELLER SHAFT ASSEMBLY
36179
17.INSTALL TRANSFER CASE LOWER PROTECTOR
Install the transfer case lower protector with the 4 bolts.
37117
18.INSTALL PROPELLER SHAFT HEAT INSULATOR
Install the propeller shaft heat insulator with the 2 bolts.
17118
19.INSTALL MANIFOLD STAY
17119
20.INSTALL NO. 2 MANIFOLD STAY
17410
21.INSTALL FRONT EXHAUST PIPE ASSEMBLY
22.ADD MANUAL TRANSMISSION OIL
23.INSPECT MANUAL TRANSMISSION OIL
33530F
24.INSTALL SHIFT LEVER ASSEMBLY
Apply MP grease to the tip of the shift lever assembly.
|
MP Grease |
Cover the shift lever cap with a cloth.
While pressing down on the shift lever cap, turn it clockwise to install the shift lever assembly.
| *1 | Shift Lever Cap |
| *a | Press down |
| *b | Clockwise |
| *c | Lock |
58286
25.INSTALL NO. 1 SHIFT AND SELECT LEVER BOOT
Install the No. 1 shift and select lever boot with the 4 screws.
Attach the 2 clips.
58810J
26.INSTALL CONSOLE BOX ASSEMBLY
for Manual Transmission: (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Manual Transmission)>INSTALLATION)
w/ Refrigerated Cool Box: (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX (w/ Refrigerated Cool Box)>INSTALLATION)
28800
27.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).