| ABS, BA and/or EBD does not operate
|
Check for DTCs again and make sure that normal system code is output.
|
( )
|
| IG power source circuit (low power supply voltage malfunction)
|
( )
|
| IG power source circuit (high power supply voltage malfunction)
|
( )
|
| Front speed sensor circuit (comparison malfunction)
|
( )
|
| Front speed sensor circuit (open or short malfunction)
|
( )
|
| Front speed sensor circuit (output malfunction)
|
( )
|
| Rear speed sensor circuit (comparison malfunction)
|
( )
|
| Rear speed sensor circuit (open or short malfunction)
|
( )
|
| Rear speed sensor circuit (output malfunction)
|
( )
|
| Check brake actuator assembly with the intelligent tester (check brake actuator assembly operation using Active Test function). If abnormal, check hydraulic circuit for leaks.
|
( )
|
| If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU)
|
( )
|
| ABS, BA and/or EBD does not operate efficiently
|
Check for DTCs again and make sure that normal system code is output
|
( )
|
| Front speed sensor circuit (comparison malfunction)
|
( )
|
| Front speed sensor circuit (open or short malfunction)
|
( )
|
| Front speed sensor circuit (output malfunction)
|
( )
|
| Rear speed sensor circuit (comparison malfunction)
|
( )
|
| Rear speed sensor circuit (open or short malfunction)
|
( )
|
| Rear speed sensor circuit (output malfunction)
|
( )
|
| Stop light switch circuit
|
( )
|
| Check brake actuator assembly with the intelligent tester (check brake actuator assembly operation using Active Test function). If abnormal, check hydraulic circuit for leaks.
|
( )
|
| If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU)
|
( )
|
| ABS warning light abnormal (Remains on)
|
ABS warning light circuit
|
( )
|
| IG power source circuit (high power supply voltage malfunction)
|
( )
|
| Brake actuator assembly (skid control ECU)
|
( )
|
| ABS warning light abnormal (Does not come on)
|
ABS warning light circuit
|
( )
|
| Brake actuator assembly (skid control ECU)
|
( )
|
| Brake warning light abnormal (Remains on)
|
Brake warning light circuit
|
( )
|
| IG power source circuit (high power supply voltage malfunction)
|
( )
|
| Brake actuator assembly (skid control ECU)
|
( )
|
| Brake warning light abnormal (Does not come on)
|
Brake warning light circuit
|
( )
|
| Brake actuator assembly (skid control ECU)
|
( )
|
| DTC check cannot be performed
|
Check for DTCs again and make sure that normal system code is output
|
( )
|
| TC and CG terminal circuit
|
( )
|
| IG power source circuit (high power supply voltage malfunction)
|
( )
|
| If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace brake actuator assembly (skid control ECU)
|
( )
|
| Sensor check cannot be performed
|
TS and CG terminal circuit
|
( )
|
| Brake actuator assembly (skid control ECU)
|
( )
|