Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › from 2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260910 ANTI-LOCK BRAKE SYSTEM T

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



NOTICE:

When replacing the skid control ECU (brake actuator assembly), sensor, etc., turn the ignition switch off.


Anti-lock Brake System
Symptom Suspected Area See page
ABS, BA and/or EBD does not operate Check for DTCs again and make sure that normal system code is output. (Click here)
IG power source circuit (low power supply voltage malfunction) (Click here)
IG power source circuit (high power supply voltage malfunction) (Click here)
Front speed sensor circuit (comparison malfunction) (Click here)
Front speed sensor circuit (open or short malfunction) (Click here)
Front speed sensor circuit (output malfunction) (Click here)
Rear speed sensor circuit (comparison malfunction) (Click here)
Rear speed sensor circuit (open or short malfunction) (Click here)
Rear speed sensor circuit (output malfunction) (Click here)
Check skid control ECU (brake actuator assembly) with the GTS (check skid control ECU (brake actuator assembly) operation using Active Test function). If abnormal, check hydraulic circuit for leaks. (Click here)
If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace skid control ECU (brake actuator assembly) (Click here)
ABS, BA and/or EBD does not operate efficiently Check for DTCs again and make sure that normal system code is output (Click here)
Front speed sensor circuit (comparison malfunction) (Click here)
Front speed sensor circuit (open or short malfunction) (Click here)
Front speed sensor circuit (output malfunction) (Click here)
Rear speed sensor circuit (comparison malfunction) (Click here)
Rear speed sensor circuit (open or short malfunction) (Click here)
Rear speed sensor circuit (output malfunction) (Click here)
Stop light switch circuit (Click here)
Check skid control ECU (brake actuator assembly) with the GTS (check skid control ECU (brake actuator assembly) operation using Active Test function). If abnormal, check hydraulic circuit for leaks. (Click here)
If symptoms still occur even after above circuits in suspected area column have been inspected and proved to be normal, replace skid control ECU (brake actuator assembly) (Click here)
ABS warning light abnormal (Remains on) ABS warning light circuit (Click here)
IG power source circuit (high power supply voltage malfunction) (Click here)
Skid control ECU (brake actuator assembly) (Click here)
ABS warning light abnormal (Does not come on) ABS warning light circuit (Click here)
Skid control ECU (brake actuator assembly) (Click here)
Brake warning light abnormal (Remains on) Brake warning light circuit (Click here)
IG power source circuit (high power supply voltage malfunction) (Click here)
Skid control ECU (brake actuator assembly) (Click here)
Brake warning light abnormal (Does not come on) Brake warning light circuit (Click here)
Skid control ECU (brake actuator assembly) (Click here)