Home › Engine / Hybrid System › 3UR-FE (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL
RM2660E _51 Engine / Hybrid System _052777 3UR-FE ENGINE MECHANICAL _0255047 FRONT CRANKSHAFT OIL SEAL A

3UR-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11301C 1.INSTALL FRONT CRANKSHAFT OIL SEAL

a.

Apply MP grease to the lip of a new oil seal.


b.
A163995E12
1.771,2.635 1.854,3.01 false 1.854,3.01 1.927,2.604 false 1.688,3.031 2.01,3.208 0.323,0.177 10 true SST

Using SST and a hammer, tap in the oil seal to a depth between 0 and 1.0 mm (0 and 0.0394 in.) from the timing chain cover edge.

SST
09223-22010  
09506-35010  

NOTICE:
·

Keep the lip free from foreign matter.

·

Do not tap the oil seal at an angle.




Hide 13521A 2.INSTALL CRANKSHAFT TIMING GEAR KEY

a.

Install the crankshaft timing gear key.


Hide 16207 6.CONNECT NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY

a.

Connect the 2 water by-pass hoses to the oil cooler.


b.

Install the 3 by-pass pipe bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 88320 7.CONNECT COOLER COMPRESSOR ASSEMBLY

Hide 83520 8.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

Hide 16571C 10.INSTALL NO. 1 RADIATOR HOSE

Hide 51405A 16.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53806 17.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 18.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH