Home › Engine / Hybrid System › 1VD-FTV (FUEL) › FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052783 1VD-FTV FUEL _0255119 FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank) A

1VD-FTV FUEL  FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank)  INSTALLATION  


PROCEDURE

Hide 83320B 1.INSTALL FUEL SENDER GAUGE ASSEMBLY

a.
A176327

Install a new gasket to the sender gauge.


b.

Install the sender gauge with the 5 screws.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)

NOTICE:

Be careful not to bend the arm of the fuel sender gauge.



c.

Connect the sender gauge connector.


Hide 58325E 2.INSTALL REAR FLOOR SERVICE HOLE COVER

a.
A176326

Install the service hole cover with new butyl tape.


Hide 87212L 3.INSTALL REAR NO. 7 AIR DUCT (w/ Rear Air Conditioning System)

a.
U163059E02
2.427,1.385 2.552,1.531 0.125,0.146 10 false 4 1.333,1.563 1.458,1.708 0.125,0.146 10 false 3 0.76,1.438 0.885,1.583 0.125,0.146 10 false 1 2.813,1.094 2.938,1.24 0.125,0.146 10 false 2

Attach the 4 clips to install the air duct.

HINT:

Attach the clips in the order shown in the illustration.



Hide 58570B 4.INSTALL REAR FLOOR MAT ASSEMBLY

a.
A176328

Attach the 5 clips to install the floor mat.


Hide 87174 5.INSTALL REAR AIR DUCT GUIDE (w/ Rear Air Conditioning System)

Hide 87217B 6.INSTALL AIR DUCT PLUG (w/ Rear Air Conditioning System)

Hide 62520P 7.INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

a.

w/ Sliding Roof:

Install the front quarter trim panel assembly LH (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>INSTALLATION).


b.

w/o Sliding Roof:

Install the front quarter trim panel assembly LH (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>INSTALLATION).


Hide 62510P 8.INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH

a.

w/ Sliding Roof:

Install the front quarter trim panel assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>INSTALLATION).


b.

w/o Sliding Roof:

Install the front quarter trim panel assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>INSTALLATION).


Hide 71845B 9.INSTALL REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

Hide 14.INSTALL REAR NO. 2 SEAT ASSEMBLY

a.

for Face to Face Seat Type:

Install the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Face to Face Seat Type)>INSTALLATION).


b.

except Face to Face Seat Type:

Install the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(except Face to Face Seat Type)>INSTALLATION).


Hide 71300S 15.INSTALL REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)

Hide 71400S 16.INSTALL REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)

Hide 17.INSTALL CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


a.

Connect the cables to the negative (-) main battery and sub-battery terminals.


Hide 18.CHECK SRS WARNING LIGHT