1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
28800
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Disconnect the cables from the negative (-) main battery and sub-battery terminals.
53292A
3.REMOVE UPPER RADIATOR SUPPORT SEAL
4.REMOVE FRONT WHEEL RH
53736G
5.REMOVE FRONT FENDER APRON SEAL FRONT RH
53806
6.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
53805
7.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
51405A
8.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
9.DRAIN ENGINE COOLANT
82113
10.REMOVE NO. 3 ENGINE ROOM WIRE
12601E
11.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Intercooler)
17705
12.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17881
13.REMOVE NO. 1 AIR CLEANER HOSE
17861
14.REMOVE INTAKE AIR CONNECTOR
44360
15.REMOVE VANE PUMP OIL RESERVOIR ASSEMBLY
44369A
16.REMOVE NO. 1 OIL RESERVOIR BRACKET
16470
17.REMOVE RADIATOR RESERVOIR ASSEMBLY
44310
18.REMOVE VANE PUMP ASSEMBLY
16571C
19.DISCONNECT NO. 1 RADIATOR HOSE
16572D
20.DISCONNECT NO. 2 RADIATOR HOSE
21.REMOVE V-RIBBED BELT (w/ Viscous Heater)
22.REMOVE NO. 1 IDLER PULLEY (w/ Viscous Heater)
23.REMOVE NO. 3 IDLER PULLEY (w/ Viscous Heater)
16361A
24.REMOVE V-RIBBED BELT
32942
25.REMOVE OIL COOLER TUBE (for Automatic Transmission)
16711
26.REMOVE FAN SHROUD WITH FAN
16371
27.REMOVE FAN PULLEY
87208
28.REMOVE HEATER WATER PIPE SUB-ASSEMBLY (w/ Viscous Heater)
87120G
29.REMOVE VISCOUS WITH MAGNET CLUTCH HEATER ASSEMBLY (w/ Viscous Heater)
30.REMOVE NO. 1 IDLER PULLEY BRACKET (w/ Viscous Heater)
16321
31.REMOVE WATER INLET
16331A
32.REMOVE THERMOSTAT
16630H
33.REMOVE NO. 2 IDLER PULLEY (w/ Viscous Heater)
Remove the bolt, cover, No. 2 idler pulley and collar.
34.REMOVE NO. 2 IDLER PULLEY BRACKET (w/ Viscous Heater)
Remove the 3 bolts and idler pulley bracket.
15777
35.DISCONNECT NO. 1 OIL COOLER HOSE
16307A
36.REMOVE FAN BRACKET SUB-ASSEMBLY
Remove the 4 bolts and fan bracket.
16331
37.REMOVE WATER OUTLET
Disconnect the engine coolant temperature sensor connector.
Remove the 2 bolts, disconnect the water outlet from the No. 2 water hose joint, and remove the water outlet and gasket.
16100
38.REMOVE WATER PUMP ASSEMBLY
Remove the 9 bolts, 2 nuts, water pump and gasket.