Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
48826D
1.REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)
48860D
2.OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)
3.REMOVE REAR WHEEL LH
4.DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH
42431
5.REMOVE REAR DISC LH
6.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING LH
46580
7.REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH
46590
8.REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH
9.REMOVE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY LH
42312E
10.REMOVE REAR AXLE HUB BOLT LH
Using SST and a screwdriver or equivalent to hold the axle hub, remove the hub bolt.
Do not deform the oil deflector.
Make sure to align the notch of SST with the flange of the oil deflector.
42312E
11.INSTALL REAR AXLE HUB BOLT LH
Temporarily install a washer and hub nut to a new hub bolt as shown in the illustration.
Install a hub nut to prevent damage to the hub bolt.
Using a screwdriver or equivalent to hold the hub, turn the hub nut until the bottom surface of the hub bolt head touches the axle hub.
Remove the washer and hub nut.
Do not damage the threads of the hub bolt.
12.INSTALL PARKING BRAKE SHOE LEVER SUB-ASSEMBLY LH
46590
13.INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY LH
46580
14.INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY LH
15.INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING LH
16.CHECK PARKING BRAKE INSTALLATION
42431
17.INSTALL REAR DISC LH
18.ADJUST PARKING BRAKE SHOE CLEARANCE
19.CONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH
20.INSTALL REAR WHEEL LH
21.CHECK PARKING BRAKE LEVER TRAVEL
22.ADJUST PARKING BRAKE LEVER TRAVEL
23.MEASURE VEHICLE HEIGHT (w/ KDSS)
48860D
24.CLOSE STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)
48826D
25.INSTALL STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)