1. TABLE OF BOLT, SCREW AND NUT
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55449C
3.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
55403C
4.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
55448A
5.REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
55402C
6.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
55406B
7.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
55318C
8.REMOVE INSTRUMENT SIDE PANEL LH
55474C
9.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55475A
10.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55606
11.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)
67914B
12.REMOVE FRONT DOOR SCUFF PLATE LH
62112
13.REMOVE COWL SIDE TRIM BOARD LH
55432D
14.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
55446A
15.REMOVE NO. 1 SWITCH HOLE BASE
73900
16.REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)
55303B
17.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)
55317A
18.REMOVE INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)
55317A
19.REMOVE INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)
67913B
20.REMOVE FRONT DOOR SCUFF PLATE RH
55607
21.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)
62111C
22.REMOVE COWL SIDE TRIM BOARD RH
73990
23.REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)
55312
24.REMOVE LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)
55476A
25.REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55443D
26.REMOVE INSTRUMENT PANEL BOX DOOR KNOB
55433B
27.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
89181A
28.REMOVE STEERING CONTROL ECU WITH JUNCTION BLOCK (for LHD)
Vehicle rear side:
Disconnect the 7 connectors.
Detach the 2 clamps.
Remove the bolt and 2 nuts.
Vehicle front side:
Disconnect the 5 connectors.
Remove the steering control ECU with junction block from the vehicle.
89181A
29.REMOVE STEERING CONTROL ECU WITH JUNCTION BLOCK (for RHD)
Vehicle rear side:
Disconnect the 2 connectors.
Remove the bolt and 2 nuts.
Vehicle front side:
Disconnect the connector.
Remove the steering control ECU with junction block from the vehicle.
89191A
30.REMOVE ACCELERATION SENSOR (for Driver Side)
Disconnect the connector.
Remove the bolt and sensor.
Use the same procedures for LHD and RHD vehicles.
89191A
31.REMOVE ACCELERATION SENSOR (for Front Passenger Side)
Disconnect the connector.
Remove the bolt and sensor.
Use the same procedures for LHD and RHD vehicles.