Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255506 PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System) T

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System)  PROBLEM SYMPTOMS TABLE  


NOTICE:

The following inspection procedures for the parking assist monitor system are based on the assumption that the navigation system is normal. If the navigation system has any malfunctions, first proceed with troubleshooting the navigation system.


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



General
Symptom Suspected Area See page
When the shift lever is in R, the parking assist monitor image is not displayed (screen is not black). Park/neutral position switch assembly (Click here)
Multi-display assembly (Click here)
Multi-media module receiver assembly (Click here)
When the shift lever is in R, the parking assist monitor image is not displayed (screen is black). Proceed to "Image from Camera for Parking Assist Monitor is Abnormal" (Click here)
Multi-display assembly (Click here)
Multi-media module receiver assembly (Click here)
When the shift lever is not in R, the parking assist monitor image is displayed. Park/neutral position switch assembly (Click here)
Multi-display assembly (Click here)
Multi-media module receiver assembly (Click here)

Display Malfunction
Symptom Suspected Area See page
Image from the camera for the parking assist monitor is abnormal. Proceed to "Image from Camera for Parking Assist Monitor is Abnormal" (Click here)

Parking Assist Monitor System Malfunction
Symptom Suspected Area See page
Projected course guide lines are not displayed. Parking assist monitor screen display mode settings. (Check if the parking guide lines are set to off.) (Click here)
Multi-display assembly (Click here)
Multi-media module receiver assembly (Click here)
"System initializing" is displayed. Correct the steering angle neutral point (Click here)
"System initializing" is displayed even after correcting the steering angle neutral point. Steering sensor (Click here)
Steering angle setting (Calibration) (Click here)
Multi-display assembly (Click here)
Multi-media module receiver assembly (Click here)
"System not ready" is displayed. Multi-media module receiver assembly initialization (Calibration) (Click here)
"System not ready" is displayed even after navigation receiver assembly initialization. Multi-display assembly (Click here)
Multi-media module receiver assembly (Click here)
During parallel parking assist mode, the screen does not change even though the vehicle has moved. If the vehicle is reversing at very low speed, the screen may not change -
During parallel parking assist mode, the screen changes even though the vehicle has not moved. If the vehicle is stopped for extended period of time, the screen may change -
Guide lines and buttons are not displayed for all parking assist monitor screen display modes. Proceed to ["Back Door is Open" is Displayed even after Back Door is Closed"] (Click here)
The guide lines and buttons remain displayed even though the luggage compartment door is open. CAN communication system (for LHD) (Click here)
CAN communication system (for RHD) (Click here)
Proceed to ["Back Door is Open" is Displayed even after Back Door is Closed"] (Click here)
When adjusting the camera optical axis, "Back door is open. Do not use the rear view monitor when the back door is not completely closed." is displayed even after the back door has been closed. Proceed to ["Back Door is Open" is Displayed even after Back Door is Closed"] (Click here)
"CHK" message(s) are displayed on the [Car Signal Check] screen. Car signal check (Diagnosis) (Click here)
When the parking assist monitor screen is displayed, the lines are misaligned. (The image from the camera is tilted.) Back camera position setting (Calibration) (Click here)