Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU (for LHD) › 2014.08–2015.08
RM2660E _57 Power Source / Network _052837 NETWORKING _0255532 NETWORK GATEWAY ECU(for LHD) A

NETWORKING  NETWORK GATEWAY ECU(for LHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Passenger Side Knee Airbag)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67913B 3.REMOVE FRONT DOOR SCUFF PLATE RH

a.

w/ Sliding Roof:

Remove the front door scuff plate (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>REMOVAL).


b.

w/o Sliding Roof:

Remove the front door scuff plate (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>REMOVAL).


Hide 55448A 4.REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

a.

w/o Console Box Lid:

i.

Remove the No. 1 instrument panel finish panel cushion (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Console Box Lid)>REMOVAL).



b.

w/ Cool Box:

i.

Remove the No. 1 instrument panel finish panel cushion (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>REMOVAL).



c.

w/o Cool Box:

i.

Remove the No. 1 instrument panel finish panel cushion (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Cool Box)>REMOVAL).



Hide 55402C 5.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

a.

w/o Console Box Lid:

i.

Remove the lower instrument panel pad sub-assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Console Box Lid)>REMOVAL).



b.

w/ Cool Box:

i.

Remove the lower instrument panel pad sub-assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>REMOVAL).



c.

w/o Cool Box:

i.

Remove the lower instrument panel pad sub-assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Cool Box)>REMOVAL).



Hide 55607 6.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 73990 7.REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

Hide 55312 8.REMOVE LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)

Hide 55476A 9.REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55443D 10.REMOVE INSTRUMENT PANEL BOX DOOR KNOB

Hide 55433B 11.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Hide 89111 12.REMOVE NETWORK GATEWAY ECU

E154163

a.

Disconnect the connector.


b.

Remove the nut and ECU.