Use the same procedures for LHD and RHD vehicles.
The procedures listed below are for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
52119A
3.REMOVE FRONT BUMPER COVER
for Standard:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(for Standard)>REMOVAL)
w/ Winch:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(w/ Winch)>REMOVAL)
4.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
88711
5.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the bolt and disconnect the discharge hose from the cooler condenser.
When removing the bolt, do not allow any tools to contact the pipe.
When removing the bolt, hold a part of the pipe near the connector.
Remove O-ring from the discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88716A
6.DISCONNECT COOLER REFRIGERANT LIQUID PIPE A
Remove the 2 bolts and disconnect the liquid pipe A from the cooler condenser.
When removing the bolt, do not allow any tools to contact the pipe.
When removing the bolt, hold a part of the pipe near the connector.
Remove O-ring from the liquid pipe A.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
86510
7.REMOVE HIGH PITCHED HORN ASSEMBLY
86520
8.REMOVE LOW PITCHED HORN ASSEMBLY
88590
9.REMOVE SHROUD BLOWER ASSEMBLY (w/ Rear Air Conditioning System)
53228A
10.REMOVE LOWER NO. 1 RADIATOR MOUNTING BRACKET
53209B
11.REMOVE HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY
Remove the 3 bolts, nut and brace.
52521
12.REMOVE FRONT BUMPER CENTER UPPER RETAINER
for Standard:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(for Standard)>REMOVAL)
w/ Winch:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(w/ Winch)>REMOVAL)
32910
13.DISCONNECT OIL COOLER ASSEMBLY (w/ Air Cooled Transmission Oil Cooler)
AB60F:
(See page Drivetrain>AB60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>OIL COOLER>REMOVAL)
A750F:
(See page Drivetrain>A750F (AUTOMATIC TRANSMISSION / TRANSAXLE)>OIL COOLER>REMOVAL)
53629
14.REMOVE HOOD LOCK CONTROL CABLE COVER
53510
15.REMOVE HOOD LOCK ASSEMBLY
16400
16.REMOVE RADIATOR ASSEMBLY
53201
17.REMOVE RADIATOR SUPPORT SUB-ASSEMBLY
Remove the 8 bolts and radiator support.
88460
18.REMOVE COOLER CONDENSER ASSEMBLY
Remove the cooler condenser as shown in the illustration.
88474
19.REMOVE COOLER DRYER
Using a 14 mm socket hexagon wrench, remove the cap from the modulator.
Remove O-ring from the cap.
Using pliers, remove the cooler dryer.