When the outer mirror switch assembly mirror surface adjust switch (up/down/left/right) is operated, up/ down/left/right signals are received by the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) sends the received signals to the outer mirror control ECU assembly LH*1, RH*2 via CAN communication. The outer mirror control ECU assembly LH*1, RH*2 receives the remote mirror selection signal and up/down/left/right signals and operates the outer rear view mirror assembly LH*1, RH*2 up/ down/left/right based on the signals.
*1: for LHD
*2: for RHD
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem (See page Vehicle Exterior>MIRROR (EXT)>POWER MIRROR CONTROL SYSTEM(w/ Retract Mirror)>HOW TO PROCEED WITH TROUBLESHOOTING).
If the main body ECU (multiplex network body ECU) is replaced, refer to the Entry and Start System (for Entry function) (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM(for Entry Function)>PRECAUTION).
Using the GTS, read the Data List. (See page Vehicle Exterior>MIRROR (EXT)>POWER MIRROR CONTROL SYSTEM(w/ Retract Mirror)>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Mirror Selection SW (L) | Mirror select switch signal for LH mirror / ON or OFF | ON: Mirror select switch is L position
OFF: Mirror select switch is except L position |
- |
| Mirror Selection SW (R) | Mirror select switch signal for RH mirror / ON or OFF | ON: Mirror select switch is R position
OFF: Mirror select switch is except R position |
- |
| Mirror Position SW (R) | Mirror surface adjust switch signal (Right) / ON or OFF | ON: Mirror surface adjust switch pressed right
OFF: Any switch except right on or all switches off |
- |
| Mirror Position SW (L) | Mirror surface adjust switch signal (Left) / ON or OFF | ON: Mirror surface adjust switch not pressed left
OFF: Any switch except left on or all switches off |
- |
| Mirror Position SW (Up) | Mirror surface adjust switch signal (Up) / ON or OFF | ON: Mirror surface adjust switch pressed up
OFF: Any switch except up on or all switches off |
- |
| Mirror Position SW (Dwn) | Mirror surface adjust switch signal (Down) / ON or OFF | ON: Mirror surface adjust switch pressed down
OFF: Any switch except down on or all switches off |
- |
On the GTS screen, each item changes between ON and OFF according to above chart.
OK
NG
*1: for LHD
*2: for RHD
Remove the outer rear view mirror assembly LH*1, RH*2 (See page Vehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>REMOVAL).
Inspect the outer rear view mirror assembly LH*1, RH*2 (See pageVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>INSPECTION ).
OK
NG
*1: for LHD
*2: for RHD
Disconnect the I40*1, I37*2 outer mirror control ECU assembly LH*1, RH*2 connector.
Disconnect the I35*1, I32*2 outer rear view mirror assembly LH*1, RH*2 connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I40-10 (LM+R) - I35-8 (M+) | Always | Below 1 Ω |
| I40-9 (LMHR) - I35-9 (MH) | ||
| I40-1 (LMVR) - I35-7 (MV) | ||
| I40-10 (LM+R) or I35-8 (M+) - Body ground | Always | 10 kΩ or higher |
| I40-9 (LMHR) or I35-9 (MH) - Body ground | ||
| I40-1 (LMVR) or I35-7 (MV) - Body ground |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I37-10 (LM+R) - I32-8 (M+) | Always | Below 1 Ω |
| I37-9 (LMHR) - I32-9 (MH) | ||
| I37-1 (LMVR) - I32-7 (MV) | ||
| I37-10 (LM+R) or I32-8 (M+) - Body ground | Always | 10 kΩ or higher |
| I37-9 (LMHR) or I32-9 (MH) - Body ground | ||
| I37-1 (LMVR) or I32-7 (MV) - Body ground |
OK
NG
Remove the outer mirror switch assembly (See page Vehicle Exterior>MIRROR (EXT)>OUTER MIRROR SWITCH>REMOVAL).
Inspect the outer mirror switch assembly (See page Vehicle Exterior>MIRROR (EXT)>OUTER MIRROR SWITCH>INSPECTION).
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C