| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | UPPER RADIATOR SUPPORT SEAL | 53292A | - | - | - |
| 2 | RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM | - | ( ) |
- | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 3 | WHEEL ASSEMBLY | - | - | - | - |
| 4 | QUARTER PANEL REAR MUDGUARD RH | 76625G | - | - | - |
| 5 | REAR BUMPER SIDE SEAL RH | 52591 | ( ) |
- | - |
| 6 | REAR WHEEL HOUSE LINER RH | 65637B | - | - | - |
| *A | w/ Rear No. 2 Seat | *B | w/o Rear No. 2 Seat |
| *C | w/ Tonneau Cover | - | - |
| *A | w/ Rear No. 2 Seat | *B | w/ Rear No. 2 Seat, Curtain Shield Airbag |
| *C | w/ Tonneau Cover | - | - |
| ● | Non-reusable part | - | - |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 29 | REAR BUMPER ASSEMBLY | - | - | - | - |
| 30 | NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR | 58723B | - | - | - |
| 31 | NO. 4 COOLER UNIT DRAIN HOSE | 88539N | - | - | - |
| *A | w/ Spacer | *B | w/ Rear No. 2 Seat, Curtain Shield Airbag |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air conditioning blower assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
53292A 1.REMOVE UPPER RADIATOR SUPPORT SEAL
for Standard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Standard)>REMOVAL
for Aero Type:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Aero Type)>REMOVAL
2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
3.REMOVE WHEEL ASSEMBLY
76625G 4.REMOVE QUARTER PANEL REAR MUDGUARD RH
Use the same procedure described for the LH side.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>MUDGUARD (for Rear)>REMOVAL
65637B 6.REMOVE REAR WHEEL HOUSE LINER RH
7.REMOVE REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)
Use the same procedure described for the LH side.
for Manual Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Manual Seat)>REMOVAL
for Power Seat:
Click hereVehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY (for Power Seat)>REMOVAL
64910M 8.REMOVE TONNEAU COVER ASSEMBLY (w/o Rear No. 2 Seat, w/ Tonneau Cover)
58410B 11.REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)
58418H 12.REMOVE REAR FLOOR BOARD REAR LH (w/o Rear No. 2 Seat)
58417B 13.REMOVE REAR FLOOR BOARD REAR RH (w/o Rear No. 2 Seat)
Use the same procedure described for the LH side.
64993 14.REMOVE REAR DECK FLOOR BOX (w/o Rear No. 2 Seat)
58574G 15.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Rear No. 2 Seat)
73233 16.REMOVE OUTER LAP BELT ANCHOR COVER
73360C 17.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR)
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT BELT>REAR NO. 1 SEAT OUTER BELT ASSEMBLY>REMOVAL
73560 18.REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR) (w/ Rear No. 2 Seat)
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT BELT>REAR NO. 1 SEAT OUTER BELT ASSEMBLY>REMOVAL
67917C 19.REMOVE REAR DOOR SCUFF PLATE RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62510M 21.REMOVE QUARTER TRIM PANEL ASSEMBLY RH
62471A 22.REMOVE INNER ROOF SIDE GARNISH RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
82161 23.DISCONNECT FLOOR WIRE
24.REMOVE COOLER PLATE
87217N 25.REMOVE REAR NO. 9 SIDE AIR DUCT
|
Remove in this Direction | - | - |
88G16N 26.DISCONNECT NO. 2 LIQUID TUBE
Remove the bolt and No. 2 liquid tube.
Remove the O-ring from the No. 2 liquid tube.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88717Z 27.DISCONNECT NO. 2 SUCTION TUBE
Remove the bolt and No. 2 suction tube.
Remove the O-ring from the No. 2 suction tube.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
87030 28.REMOVE AIR CONDITIONING BLOWER ASSEMBLY
29.REMOVE REAR BUMPER ASSEMBLY
Perform this procedure only when replacement of the No. 4 cooler unit Drain hose is necessary.
for Standard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Standard)>REMOVAL
for Aero Type:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Aero Type)>REMOVAL
58723B 30.REMOVE NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Perform this procedure only when replacement of the No. 4 cooler unit Drain hose is necessary.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Standard)>DISASSEMBLY
88539N 31.REMOVE NO. 4 COOLER UNIT DRAIN HOSE
Perform this procedure only when replacement of the No. 4 cooler unit Drain hose is necessary.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING UNIT>REMOVAL
32.REMOVE ROOF HEADLINING ASSEMBLY
62170A 33.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH (w/ Rear No. 2 Seat, Curtain Shield Airbag)
62495B 34.REMOVE NO. 2 ROOF SIDE INNER GARNISH SPACER RH (w/ Spacer)
88566S 35.REMOVE REAR NO. 2 ROOF AIR DUCT
88566U 36.REMOVE REAR NO. 4 ROOF AIR DUCT
88566T 37.REMOVE REAR NO. 3 ROOF AIR DUCT
88566R 38.REMOVE REAR NO. 1 ROOF AIR DUCT