Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM
RM38G0E _56 Audio / Visual / Telematics _100728 PARK ASSIST / MONITORING _0469676 PANORAMIC VIEW MONITOR SYSTEM T

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

The following inspection procedure of the panoramic view monitor system is described on the assumption that the audio and visual system*1 or navigation system*2 is normal. If the audio and visual system*1 or navigation system*2 has any malfunction, first proceed with troubleshooting of the audio and visual system*1 or navigation system*2.

*1: w/ Audio and Visual System

*2: w/ Navigation System


·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION



HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


General
Symptom Suspected Area Link
Screen does not switch when the panoramic view monitor switch (trip switch) is pressed. Proceed to "ECU Power Source Circuit" Click here
Diagnostic mode - Signal connection check (CAMERA SW check) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Does not switch to the panoramic view and rear view screen when the shift lever is in R. Diagnostic mode - Signal connection check (CAN check) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Image not displayed on the panoramic view and rear view screen or rear view screen when the shift lever is in R. Proceed to "Image from Camera for Panoramic View Monitor is Abnormal" Click here
Display does not switch to the see through view screen or moving view screen when the panoramic view monitor switch is pressed. Diagnostic mode - Signal connection check (CAN check) Click here
Diagnostic mode - Signal connection check (CAMERA SW check) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Image not displayed on the see through view screen or moving view screen when the panoramic view monitor switch is pressed. Proceed to "Image from Camera for Panoramic View Monitor is Abnormal" Click here
Display does not switch to the panoramic view and wide front view screen or side clearance view screen when the panoramic view monitor main switch is pressed. Diagnostic mode - Signal connection check (CAN check) Click here
Diagnostic mode - Signal connection check (CAMERA SW check) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Image not displayed on the panoramic view and wide front view screen or side clearance view screen when the panoramic view monitor main switch is pressed. Proceed to "Image from Camera for Panoramic View Monitor is Abnormal" Click here
Display does not switch to the retracted screen when the outer mirrors are retracted. Diagnostic mode - Signal connection check (CAN check) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Display does not switch from the retracted screen when the outer mirrors are not in the retracted position. Diagnostic mode - Signal connection check (CAN check) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here

Display Malfunction
Symptom Suspected Area Link
Objects not displayed correctly on the panoramic view monitor screen (color, distorted image). Proceed to "Image from Camera for Panoramic View Monitor is Abnormal" Click here
Distorted display on panoramic view screen. Camera view adjustment (calibration) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Parking lines do not match at front and rear on panoramic view screen. Camera view adjustment (calibration) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Partial black screen on panoramic view screen. Camera view adjustment (calibration) Click here
Proceed to "Image from Camera for Panoramic View Monitor is Abnormal" Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Area displayed differs from the actual area. Ensure no door is opened -
Camera view adjustment (calibration) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here

Switch Function
Symptom Suspected Area Link
Panoramic view monitor switch (trip switch) night illumination does not illuminate. Inspect panoramic view monitor switch (trip switch) Click here
Harness and connector -
Touch switch operation is not accepted. Audio and visual system - Touch switch self check*1 Click here
Navigation system - Touch switch self check*2 Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Radio receiver assembly Click here
The remote touch function of the screen does not operate for the panoramic view monitor system. Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Radio receiver assembly Click here

*1: w/ Audio and Visual System

*2: w/ Navigation System


Panoramic View Monitor System Function
Symptom Suspected Area Link
When the vehicle speed increases in the automatic display mode, the panoramic view and wide front view screen or side clearance view screen remains displayed, without switching to the navigation screen. Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
The screen display timer function does not operate if the manual display mode is selected. Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
The estimated course lines do not match the vehicle width extension lines when the steering wheel points straight ahead. Check the steering wheel installation angle Click here
Adjust steering angle Click here
Camera view adjustment (calibration) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Estimated course lines stop moving before the steering wheel is turned fully left. Steering angle setting (calibrate stored maximum steering angle) Click here
"!" is displayed and estimated course lines are not displayed. Check if the back door is not open -
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Radio receiver assembly Click here
Estimated course lines are not displayed. Check the panoramic view monitor screen display mode settings (Check if the estimated course lines display is set to off) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
"!" is displayed. Store the steering angle sensor steering neutral point Click here
Diagnostic mode - Signal connection check (CAN check) Click here
"!" remains displayed after the steering neutral point is stored. Adjust steering angle Click here
Steering sensor Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
"!" is displayed and all the buttons on the screen are grayed out. Camera view adjustment (calibration) Click here
Adjust steering angle Click here
Audio and Visual System*1 Click here
Navigation System*2 Click here
"!" is displayed and all the buttons on the screen are grayed out even after television camera controller initialization has been completed. Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Audio and Visual System*1 Click here
Navigation System*2 Click here
Guide lines and buttons are not displayed on the panoramic view and rear view screen display screen. Check if the back door is not open -
Check if the luggage light turns on and off normally (If not, refer to Lighting System (INT) - Problem Symptoms Table) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
"CHK" is displayed for an item on the Vehicle Signal Check screen. Diagnostic mode - Signal connection check Click here
Blind spots in image. Ensure no door is opened -
Camera view adjustment (calibration) Click here
Camera boundary lines are poorly connected. Camera view adjustment (calibration) Click here
Estimated course lines are displaced. Camera view adjustment (calibration) Click here
Adjust steering angle Click here
All buttons on the panoramic view monitor are continuously grayed out Audio and Visual System*1 Click here
Navigation System*2 Click here
When adjusting the camera optical axis, "You can not calibrate the camera when the door is open. Please close the door." is displayed even after the back door has been closed Check if the luggage light turns on and off normally (If not, refer to Lighting System (INT) - Problem Symptoms Table) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here

*1: w/ Audio and Visual System

*2: w/ Navigation System


Rear Camera Detection Function
Symptom Suspected Area Link
When the multi-display screen is displayed, "RCD unavailable" is displayed. Correct the steering angle neutral point (Initialization) Click here
Blind spot monitor system -
Rear television camera assembly Click here
When the multi-display screen is displayed, "RCD malfunction. Visit your dealer" is displayed. Rear television camera assembly Click here
The indicator does not respond when the mute switch is pushed. Audio and visual system - Touch switch self check*1 Click here
Navigation system - Touch switch self check*2 Click here
Rear television camera assembly Click here
Parking Assist ECU Click here
Multi-display assembly Click here
When there is a pedestrian in the detection area, no pedestrian is detected. "Notes for Rear Camera Detection Function" in precaution Click here
Calibration Click here
Rear television camera assembly Click here
When there is no pedestrian in the detection area, a pedestrian is detected. "Notes for Rear Camera Detection Function" in precaution Click here
Calibration Click here
Rear television camera assembly Click here
A pedestrian who is in the absolute no detection area is detected. Calibration Click here
Rear television camera assembly Click here
A pedestrian is only detected when they are in the absolute detection area. Calibration Click here
Rear television camera assembly Click here

*1: w/ Audio and Visual System

*2: w/ Navigation System