The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel filter removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
Do not try to remove the black nylon tube as it is welded to the fuel suction with pump and gauge tube assembly.
Click hereEngine / Hybrid System>V35A-FTS (FUEL)>FUEL SYSTEM>PRECAUTION
1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
77020A 4.REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
83320 5.REMOVE FUEL SENDER GAUGE ASSEMBLY
77024A 6.REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY
77131C 7.REMOVE NO. 1 FUEL SUB-TANK
77174 8.REMOVE NO. 1 FUEL SUCTION SUPPORT
23220A 9.REMOVE FUEL WITH FILTER PUMP ASSEMBLY
23070 10.REMOVE FUEL MAIN VALVE ASSEMBLY
23070 11.INSTALL FUEL MAIN VALVE ASSEMBLY
23220A 12.INSTALL FUEL WITH FILTER PUMP ASSEMBLY
77174 13.INSTALL NO. 1 FUEL SUCTION SUPPORT
77131C 14.INSTALL NO. 1 FUEL SUB-TANK
77024A 15.INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY
83320 16.INSTALL FUEL SENDER GAUGE ASSEMBLY
77020A 17.INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
18.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
19. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
20.INSPECT FOR FUEL LEAK