16268 1.INSTALL NO. 1 WATER BY-PASS PIPE (w/ Heater)
|
Toyota Genuine Adhesive 1324, Three Bond 1324 or Equivalent |
Apply adhesive around the No. 1 water by-pass pipe.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the No. 1 water by-pass pipe to the cylinder block with the bolt.
88431 2.INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET (w/ Air Conditioning System)
Install the No. 1 compressor mounting bracket to the cylinder head sub-assembly and cylinder block with the 4 bolts.
88444 3.INSTALL IDLE PULLEY BRACKET (w/ Air Conditioning System)
Install the idle pulley bracket to the No. 1 compressor mounting bracket with the 2 bolts.
19850 4.INSTALL GLOW PLUG ASSEMBLY
19871 5.INSTALL NO. 1 GLOW PLUG CONNECTOR
13528 6.INSTALL CAMSHAFT DRIVE GEAR
13505 7.INSTALL NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
8.SET NO. 1 CYLINDER TO BDC/COMPRESSION
13568 9.INSTALL TIMING BELT
13540 10.SET NO. 1 CHAIN TENSIONER ASSEMBLY
13540 11.INSTALL NO. 1 CHAIN TENSIONER ASSEMBLY
12.CHECK VALVE TIMING
11322A 13.INSTALL NO. 1 TIMING BELT COVER
16331 14.INSTALL OUTLET WATER
Install a new gasket and outlet water with the 2 nuts.
15.INSTALL VACUUM PUMP ASSEMBLY
Install a new O-ring to the vacuum pump assembly.
Install the vacuum pump assembly with the 2 nuts.
16.INSTALL VACUUM PUMP TUBE
Install the vacuum pump tube with the bolt, 2 union bolts and 4 new gaskets.
16331A 17.INSTALL THERMOSTAT
16321 18.INSTALL WATER INLET
12311 19.INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET RH
Install the front No. 1 engine mounting bracket RH with the 4 bolts.
12315 20.INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET LH
Install the front No. 1 engine mounting bracket LH with the 4 bolts.
83530 21.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY (w/o Oil Pressure Gauge)
83520 22.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY (w/ Oil Pressure Gauge)
22100 23.INSTALL INJECTION PUMP
24.CHECK INJECTION TIMING
25.INSTALL INJECTION PIPE SUB-ASSEMBLY
17111 26.INSTALL INTAKE MANIFOLD
25860A 27.INSTALL NO. 1 VACUUM SWITCHING VALVE
78103 28.INSTALL NO. 1 ACCELERATOR CONNECTING ROD SUB-ASSEMBLY
78104 29.INSTALL NO. 2 ACCELERATOR CONNECTING ROD SUB-ASSEMBLY
17113 30.INSTALL INTAKE PIPE
11452 31.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
15601 32.INSTALL OIL FILTER SUB-ASSEMBLY
33.INSTALL EXHAUST MANIFOLD ASSEMBLY
17167 34.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
25620 35.INSTALL EGR VALVE ASSEMBLY (w/ EGR System)
25601 36.INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY (w/ EGR System)
17138A 37.INSTALL INTAKE PIPE STAY