Home › Engine / Hybrid System › 1HZ (LUBRICATION) › OIL PUMP
RM25T0E _51 Engine / Hybrid System _029209 1HZ LUBRICATION _0134030 OIL PUMP A

1HZ LUBRICATION  OIL PUMP  REMOVAL  


PROCEDURE

Hide 11385 3.REMOVE CAMSHAFT OIL SEAL RETAINER

Hide 13523P 4.REMOVE CAMSHAFT TIMING PULLEY

Hide 11322F 9.REMOVE NO. 2 TIMING GEAR COVER

Hide 11302A 10.REMOVE FRONT CRANKSHAFT OIL SEAL

Hide 11.REMOVE INJECTION PUMP DRIVE GEAR OIL SEAL

Hide 13525 12.INSPECT THRUST CLEARANCE NO. 1 IDLE GEAR

Hide 13522C 13.REMOVE PUMP DRIVE SHAFT GEAR

Hide 13613 15.REMOVE INJECTION PUMP DRIVE GEAR

Hide 12101 16.REMOVE OIL PAN SUB-ASSEMBLY

a.
A326408

Remove the 27 bolts and 3 nuts.


b.
A303108

Insert the blade of an oil pan seal cutter between the oil pan sub-assembly and cylinder block sub-assembly, cut through the applied sealer and remove the oil pan sub-assembly.

NOTICE:
·

Do not use the oil pan seal cutter for the area between the oil pan sub-assembly and cylinder block sub-assembly.

·

Be careful not to damage the oil pan sub-assembly flange.




Hide 15104 17.REMOVE OIL STRAINER SUB-ASSEMBLY

a.
A326409

Remove the 2 bolts, 2 nuts, oil strainer sub-assembly and gasket.


Hide 11301 18.REMOVE TIMING GEAR CASE SUB-ASSEMBLY

a.
A326410C01
0.531,1.583 0.531,0.75 true 0.448,1.573 0.76,1.729 0.313,0.156 10 false *a
*a Period Line


Before removing the injection pump assembly, check if the period lines are aligned.

If not, place new matchmarks for reinstallation.


b.

Remove the 2 nuts.


c.
A326411

Remove the 7 bolts.


d.
A326412

Using a plastic-faced hammer, lightly tap out the timing gear case sub-assembly.


e.

Remove the gasket from the timing gear case sub-assembly.