1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
51442 3.REMOVE NO. 2 ENGINE UNDER COVER
4.DRAIN ENGINE COOLANT
16571C 5.REMOVE NO. 1 RADIATOR HOSE
16711 6.REMOVE FAN SHROUD
17705 7.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE
67914 8.REMOVE FRONT DOOR SCUFF PLATE LH
for 2 door: (Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Single Cab)>REMOVAL)
for 4 door: (Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Double Cab)>REMOVAL)
67913 9.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure described for the LH side.
62112A 10.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
for 2 door: (Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Single Cab)>REMOVAL)
for 4 door: (Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Double Cab)>REMOVAL)
62111A 11.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
58191 12.REMOVE FRONT FLOOR FOOTREST
for LHD: (Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT FLOOR FOOTREST(for RHD)>REMOVAL)
for RHD: (Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT FLOOR FOOTREST(for RHD)>REMOVAL)
58811B 13.REMOVE CONSOLE BOX
89179A 14.REMOVE AIRBAG SENSOR COVER
89170 15.REMOVE AIRBAG SENSOR ASSEMBLY WITH AIRBAG SENSOR BRACKET (w/ Airbag System)
89441A 16.REMOVE DECELERATION SENSOR (w/ ABS)
36303 17.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
58286 18.REMOVE NO. 1 SHIFT AND SELECT LEVER BOOT
33530F 19.REMOVE TRANSMISSION SHIFT LEVER ASSEMBLY
| *a | Cloth or Equivalent |
|
Down |
|
Counterclockwise |
Cover the shift lever cap with a cloth or equivalent.
While pressing down on the shift lever cap, turn it counterclockwise to remove the transmission shift lever assembly.
Pull out the transmission shift lever assembly.
20.REMOVE TRANSFER SHIFT LEVER ASSEMBLY
36308 21.DISCONNECT HIGH AND LOW SHIFT ROD SUB-ASSEMBLY
Remove the nut and washer, disconnect the high and low shift rod sub-assembly.
22.DRAIN MANUAL TRANSMISSION OIL
Remove the drain plug sub-assembly and gasket, and then drain the manual transmission oil.
Install a new gasket and the drain plug sub-assembly.
51447C 23.REMOVE TRANSFER CASE PROTECTOR
Remove the 3 bolts and transfer case protector from the No. 2 frame crossmember sub-assembly.
17410 24.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for Model Code #J78, #J79 Series)
17410 25.REMOVE FRONT EXHAUST PIPE ASSEMBLY (for Model Code #J71, #J76 Series)
17118 26.REMOVE NO. 1 EXHAUST MANIFOLD STAY
17119 27.REMOVE NO. 2 MANIFOLD STAY
37140 28.REMOVE FRONT PROPELLER SHAFT ASSEMBLY
37110 29.REMOVE REAR PROPELLER SHAFT ASSEMBLY
28100 30.REMOVE STARTER ASSEMBLY
31121 31.REMOVE NO. 1 CLUTCH HOUSING COVER
31470 32.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY
Remove the 4 bolts and disconnect the clutch release cylinder assembly.
33.REMOVE FRONT STABILIZER BRACKET LH
Remove the 2 bolts and front stabilizer bracket LH.
34.REMOVE FRONT STABILIZER BRACKET RH
Use the same procedures described for the LH side.
35.SUPPORT MANUAL TRANSMISSION
Support the manual transmission with a transmission jack.
51203 36.REMOVE NO. 2 FRAME CROSSMEMBER SUB-ASSEMBLY
|
Nut |
|
Bolt |
Remove the 8 bolts.
Remove the 2 nuts and No. 2 frame crossmember sub-assembly.
12371 37.REMOVE REAR ENGINE MOUNTING INSULATOR
Remove the 4 bolts and rear engine mounting insulator from the manual transmission with transfer.
38.DISCONNECT WIRE HARNESS
Remove the bolt and disconnect the No. 2 cable bond.
Remove the clamp and disconnect the wire harness from the manual transmission.
Tilt the manual transmission together with the transfer downward.
Support the engine assembly with the jack and engine lifter so that it is stable as shown in the illustration.
Disconnect the connectors and clamps, and then disconnect the wire harness from the manual transmission.
39.REMOVE MANUAL TRANSMISSION WITH TRANSFER
Remove the 9 bolts and manual transmission with transfer.
Do not use excess force to pry off the transmission.
36112B 40.REMOVE REAR NO. 1 TRANSFER CASE HOSE
Disconnect the clamp.
Slide the clip and disconnect the rear No. 1 transfer case hose from the manual transmission.
41.REMOVE TRANSFER ASSEMBLY
Remove the 6 bolts and transfer assembly from the manual transmission.
42.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the 2 bolts and 2 wire harness clamp brackets.
Remove the bolt and air fuel ratio sensor bracket LH.
Remove the bolt and air fuel ratio sensor bracket RH.
Remove the bolt and heated oxygen sensor bracket LH.
Remove the bolt and heated oxygen sensor bracket RH.
31204 43.REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY
31237 44.REMOVE CLUTCH RELEASE FORK SUPPORT BOOT
31236B 45.REMOVE RELEASE FORK SUPPORT