Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

SMART KEY SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Smart key system 
Symptom
Suspected area
See page
Power mode does not change to ON (IG and ACC)
1. Power source control ECU
-
2. AM1 fuse
-
3. AM2 fuse
-
4. Power switch
Click here
5. Key slot
Click here
6. Wire harness
Click here
Power mode does not change to ON (ACC)
1. Power source control ECU
-
2. AM1 fuse
-
3. AM2 fuse
-
4. ACC relay
-
5. Wire harness
Click here
Power mode does not change to ON (IG)
1. Power source control ECU
-
2. AM1 fuse
-
3. AM2 fuse
-
4. IG1 relay
-
5. IG2 relay
-
6. Wire harness
Click here
Power mode does not change to ON (READY)
1. Power source control ECU
-
2. Stop light switch
Click here
3. Wire harness
Click here