| System does not operate normally even when DTCs are not output
|
Power source circuit
|
( )
|
| Seat belt warning system
|
( )
|
| Pre-crash Safety Brake Cancel Switch Circuit
|
( )
|
| Front seat inner belt assembly RH
|
( )
|
| Front seat inner belt assembly LH
|
( )
|
| Seat belt control ECU
|
( )
|
| Only pre-crash brake operation is not performed
|
Pre-crash Safety Brake Cancel Switch Circuit
|
( )
|
| Driving support ECU assembly
|
( )
|
| Skid control ECU (for LHD)
|
( )
|
| Skid control ECU (for RHD)
|
( )
|
| Although there is no possibility of crash, pre-crash controls (all front crash controls) operate
|
Proceed to "Cases of Unnecessary Pre-crash System Operation" (Although there is no possibility of crash, the millimeter wave radar sensor detects an object and activates the pre-crash system)
|
( )
|
| Check installation condition of millimeter wave radar sensor
|
( )
|
| Perform millimeter wave radar sensor adjustment
|
( )
|
| Millimeter wave radar sensor
|
( )
|
| Seat belt control ECU
|
( )
|
| Driving support ECU assembly
|
( )
|
| Although there is possibility of crash, pre-crash controls (all front crash controls) do not operate
|
Pre-crash Safety Brake Cancel Switch Circuit
|
( )
|
| Vehicle condition/environment does not match pre-crash control operation conditions (Confirm control operation conditions)
|
( )
|
| Check installation condition of millimeter wave radar sensor
|
( )
|
| Perform millimeter wave radar sensor adjustment
|
( )
|
| Millimeter wave radar sensor
|
( )
|
| Seat belt control ECU
|
( )
|
| Driving support ECU assembly
|
( )
|
| Pre-crash system OFF (pre-crash brake) does not operate
|
LED (perform Active test)
|
( )
|
| Pre-crash Safety Brake Cancel Switch Circuit
|
( )
|
| Meter circuit plate
|
( )
|
| Skid control ECU (for LHD)
|
( )
|
| Skid control ECU (for RHD)
|
( )
|
| Only pre-crash seat belt does not operate
|
Buckle switch error (malfunction in which DTC is not output)
|
-
|
| Seat belt control ECU
|
( )
|