Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM › from 2020.08
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301741 INTELLIGENT PARKING ASSIST SYSTEM T

PARK ASSIST / MONITORING  INTELLIGENT PARKING ASSIST SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

The following inspection procedures for the intelligent parking assist system are based on the assumption that the navigation system is normal. If the navigation system has any malfunctions, first proceed with troubleshooting the navigation system.

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).



HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


General
Symptom Suspected Area See page
When the shift lever is in R, an image of the area behind the vehicle is not displayed (screen is not black) Proceed to "Reverse Signal Circuit" (Click here)
Navigation receiver assembly (Click here)
When the shift lever is in R, an image of the area behind the vehicle is not displayed (screen is black) Proceed to "ECU Power Source Circuit" (Click here)
Proceed to "Image from Camera for Intelligent Parking Assist is Abnormal" (Click here)
Parking assist ECU (Click here)
When the shift lever is not in R, an image of the area behind the vehicle is displayed Proceed to "Reverse Signal Circuit" (Click here)
Navigation receiver assembly (Click here)
Parking assist ECU (Click here)

Display Malfunction
Symptom Suspected Area See page
Intelligent parking assist display malfunction (distortion of the color/screen) occurs continuously Proceed to "Image from Camera for Intelligent Parking Assist is Abnormal" (Click here)
Parking assist ECU (Click here)
Estimated course lines are displayed with steering linked lines and fixed lines overlapping Proceed to "Guide Lines are Displayed with Vehicle Center Line" (Click here)
Intelligent parking assist display malfunction (distortion of the color/screen) occurs temporarily Check the usage conditions (explain to the customer that the display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver) -

Switch Malfunction
Symptom Suspected Area See page
The illumination of the parking assist pre support switch assembly does not illuminate Parking assist pre support switch assembly inspection (Click here)
Harness or connector -
The touch switches on the navigation receiver assembly display do not operate at all Touch SW inspection (Click here)
Navigation receiver assembly (Click here)
Parking assist ECU (Click here)

Pre Support Function Malfunction
Symptom Suspected Area See page
Pre support function does not operate Pre support function operation condition (System Description) (Click here)
Signal check (Diagnosis System) (Click here)
Parking assist ECU (Click here)
When the target parking position is set after pre support operation, the initial display position of the target parking space is very far from the actual parking space Pre support function (System Description) (Click here)
Notes for ultrasonic sensor (Precaution) (Click here)
No. 1 ultrasonic sensor (Click here)
Front bumper cover (Click here)
Parking assist ECU (Click here)
"Check IPA System. Have your vehicle checked by a dealer." is displayed on the pre support screen Parking assist ECU (Click here)
Signal check (Diagnosis system) (Click here)
"IPA not available now." is displayed on the pre support screen Parking assist ECU (Click here)
"IPA not available now." is displayed on the pre support screen though the steering angle neutral point has been corrected Spiral cable with sensor sub-assembly (Click here)
Steering angle setting (Diagnosis System) (Click here)
Parking assist ECU (Click here)

Intelligent Parking Assist Function Malfunction
Symptom Suspected Area See page
The vehicle width extension lines do not overlap with the predicted path lines when the steering wheel is centered Check the installation of steering wheel -
Steering angle setting (Diagnosis System) (Click here)
Check the installation of rear television camera assembly (Click here)
Height control sensor vehicle height difference setting (Click here)
Rear television camera optical axis adjustment (Click here)
Parking assist ECU (Click here)
The predicted path lines stop before the steering wheel is turned to the lock position Steering angle setting (Diagnosis System) (Click here)
"Check IPA System. Have your vehicle checked by a dealer." is displayed on the intelligent parking assist screen Parking assist ECU (Click here)
Projected course guide lines are not displayed on the intelligent parking assist screen Parking assist ECU (Click here)
"System initializing." is displayed Correct the steering angle neutral point (Click here)
"System initializing." is displayed though the steering angle neutral point has been corrected Spiral cable with sensor sub-assembly (Click here)
Steering angle setting (Diagnosis System) (Click here)
Parking assist ECU (Click here)
"System not ready." is displayed Parking assist ECU initialization (Click here)
"System not ready." is displayed though the parking assist ECU initialization has been performed Parking assist ECU (Click here)
Assist operation stops frequently ("System cannot assist under current conditions." is displayed) Inspect the tires (tire size, tire pressure, tire wear) -
Parking assist ECU (Click here)
Assist operation stops frequently ("Use on flat surface." is displayed) Parking assist ECU (Click here)
The set parking position and actual parking position are misaligned either to the right or left in parallel parking mode Parallel parking offset (Diagnosis System) (Click here)
A rear bumper edge and a bumper reference line swerve at the intelligent parking assist screen Check the installation of the rear television camera assembly (Click here)
Height control sensor vehicle height difference setting (Click here)
Rear television camera optical axis adjustment (Click here)
Parts of the bumper reference line are not displayed Height control sensor vehicle height difference setting (Click here)
Rear television camera optical axis adjustment (Click here)
The vehicle does not move to the set parking position Proceed to "Vehicle does not move to set parking position" (Click here)
When the target parking position is set, the initial display position of the target parking space is very far from the actual parking position Notes for ultrasonic sensor (Precaution) (Click here)
No. 1 ultrasonic sensor (Click here)
Front bumper cover (Click here)
Parking assist ECU (Click here)
"CHK" message(s) are displayed on the SIGNAL CHECK screen Proceed to ""CHK" message(s) are displayed on the SIGNAL CHECK screen" (Click here)
When adjusting the camera optical axis, "Back door is open. Do not use the rear view monitor when the back door is not completely closed." is displayed even after the luggage compartment door has been closed Check that the No. 1 luggage compartment light assembly illuminates normally (if not, refer to Lighting System (INT) - Problem Symptoms Table) (Click here)
Parking assist ECU (Click here)

Guide Voice Malfunction
Symptom Suspected Area See page
The guide voice for the intelligent parking assist system is inaudible or too quiet (the voice for the navigation system is normal) Check DTCs (Click here)
Parking assist ECU (Click here)
Navigation receiver assembly (Click here)