Home › Drivetrain › P610 HYBRID TRANSMISSION / TRANSAXLE › ELECTRONIC SHIFT LEVER SYSTEM
RM3210E _52 Drivetrain _047503 P610 HYBRID TRANSMISSION / TRANSAXLE _0243554 ELECTRONIC SHIFT LEVER SYSTEM C

P610 HYBRID TRANSMISSION / TRANSAXLE  ELECTRONIC SHIFT LEVER SYSTEM  P272C00  Park Pawl Motor Driving Time Too Long  


DESCRIPTION

The hybrid vehicle control ECU receives a P position switch signal from the P position switch (transmission shift main switch) and operates the parking lock motor through current control to engage and release the parking lock.

If the hybrid vehicle control ECU detects a malfunction when operating the shift control actuator assembly, it stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory
P272C00 Park Pawl Motor Driving Time Too Long A shift control actuator assembly (parking lock motor) internal malfunction (parking lock motor spins freely) is detected for 2 seconds or more.
·

Shift control actuator assembly

·

Hybrid vehicle transaxle assembly

·

Hybrid vehicle control ECU


·

Master Warning Light

·

Comes on



·

Multi-information Display Error Message

·

Displayed



DTC stored

CONFIRMATION DRIVING PATTERN

HINT:

After repairs have been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click hereDrivetrain>P610 HYBRID TRANSMISSION / TRANSAXLE>ELECTRONIC SHIFT LEVER SYSTEM>UTILITY

1.

Turn the power switch on (IG).

2.

With the brake pedal depressed, select neutral (N).

3.

Push the P position switch (transmission shift main switch).



WIRING DIAGRAM

Refer to the wiring diagram for DTC P1C8F14.

Click hereDrivetrain>P610 HYBRID TRANSMISSION / TRANSAXLE>ELECTRONIC SHIFT LEVER SYSTEM>P1C8F14

CAUTION / NOTICE / HINT

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

1.CHECK SHIFT CONTROL ACTUATOR ASSEMBLY

OK

2.CHECK HYBRID VEHICLE TRANSAXLE ASSEMBLY

NG

REPLACE SHIFT CONTROL ACTUATOR ASSEMBLY

2.CHECK HYBRID VEHICLE TRANSAXLE ASSEMBLY

OK

NG

REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY