23.
INSTALL FLYWHEEL HOUSING UNDER COVER (for Manual Transaxle)
Install the cover with the 2 bolts.
Torque:
9.0 N*m{
92 kgf*cm
, 80 in.*lbf
}
24.
INSTALL REAR ENGINE MOUNTING BRACKET
for U140F: Install the mounting bracket with the 3 bolts.
Torque:
45 N*m{
459 kgf*cm
, 33 ft.*lbf
}
for E352F/E359F: Install the mounting bracket with the 3 bolts.
Torque:
45 N*m{
459 kgf*cm
, 33 ft.*lbf
}
for EA64F: Install the mounting bracket with the 4 bolts.
Torque:
45 N*m{
459 kgf*cm
, 33 ft.*lbf
}
25.
INSTALL TRANSAXLE WITH ENGINE ASSEMBLY
for 1AZ-FE: Install the transaxle with engine (Click here).
for 2AZ-FE: Install the transaxle with engine (Click here).
for 2AD-FTV: Install the transaxle with engine (Click here).
for 2AD-FHV: Install the transaxle with engine (Click here).
26.
INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Align the matchmarks of the transfer and propeller shaft.
Temporarily install the propeller shaft with center bearing with the 4 nuts and 4 washers.
Align the matchmarks of the differential carrier and propeller shaft.
Temporarily install the propeller shaft with center bearing with the 4 bolts and 4 washers.
Temporarily install the center support bearing and center support bearing washer with the 2 bolts.
27.
ADD AUTOMATIC TRANSAXLE FLUID
28.
INSPECT AUTOMATIC TRANSAXLE FLUID
HINT:
Drive the vehicle so that the engine and transaxle are at normal operating temperature.
Fluid temperature:
70 to 80°C (158 to 176°F)
Park the vehicle on a level surface and set the parking brake.
With the engine idling and the brake pedal depressed, move the shift lever to each position from P to L position, and return it to the P position.
Take out the ATF dipstick and wipe it clean.
Fully push the dipstick back into the pipe.
Take it out and check that the fluid level is at the HOT position. If there are leaks, it is necessary to repair or replace O-rings, FIPGs, oil seals, plugs and/or other parts.
29.
ADD TRANSAXLE OIL
30.
INSPECT TRANSAXLE OIL
for E352F/E359F: Inspect transaxle oil (Click here).
Remove the transfer case plug No. 2 (for filler) and gasket.
Check that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole. If the result is not as specified, add transfer oil.
Oil grade:
GL-5
Viscosity:
SAE 80W-90
Standard capacity:
0.45 liter (0.48 US qts, 0.40 Imp. qts)
NOTICE:
When adding oil, pour it slowly.
Too much or too little oil will lead to transfer problems.
When the oil level is too low, check for oil leakage.
Install a new gasket into the case plug (for filler) and then tighten the plug.