Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
86101
1.INSTALL ANTENNA CORD SUB-ASSEMBLY (for LHD)
w/o Telematics Transceiver, w/ Navigation ECU:
Attach the clamp to install the antenna cord sub-assembly.
Attach the claw and connect the connector.
w/ Antenna Divider:
Attach the clamp to install the antenna cord sub-assembly.
Connect the connector.
| *A | w/ Telematics Transceiver | - | - |
86101
2.INSTALL ANTENNA CORD SUB-ASSEMBLY (for RHD)
w/o Telematics Transceiver, w/ Navigation ECU:
Attach the clamp to install the antenna cord sub-assembly.
Attach the claw and connect the connector.
w/ Antenna Divider:
Attach the clamp to install the antenna cord sub-assembly.
Connect the connector.
| *A | w/ Telematics Transceiver | - | - |
w/o Telematics Transceiver, w/o Navigation ECU:
Attach the clamp to install the antenna cord sub-assembly.
Attach the claw and connect the connector.
55972C
3.INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT
55086
4.INSTALL NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY
55950G
5.INSTALL DEFROSTER NOZZLE ASSEMBLY
6.INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for A25A-FKS:
for M20A-FKS:
for A25A-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
65351A
8.INSTALL BATTERY HOLE COVER (for HV Model)
58416K
9.INSTALL REAR NO. 2 FLOOR BOARD (for HV Model)
58410B
10.INSTALL DECK BOARD ASSEMBLY (for HV Model)
11. PERFORM DIAGNOSTIC SYSTEM CHECK
w/o Occupant Classification System:
for Gasoline Model with Occupant Classification System:
for HV Model with Occupant Classification System:
12.CHECK SRS WARNING LIGHT
w/o Occupant Classification System:
for Gasoline Model with Occupant Classification System:
for HV Model with Occupant Classification System:
13.PERFORM SYSTEM INITIALIZATION AND CALIBRATION