Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
73960A
1.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
|
Hold Here |
While holding the positions shown in the illustration, attach the instrument panel passenger airbag assembly hook near the rear of the vehicle to the airbag door wall near the rear of the vehicle.
|
Install in this Direction |
Slowly lower the instrument panel passenger airbag assembly to attach the instrument panel passenger airbag assembly hook near the front of the vehicle to the airbag door wall near the front of the vehicle.
Install the 2 screws.
82142A
2.INSTALL NO. 2 INSTRUMENT PANEL WIRE
for Dual Type:
| *a | Lock Button |
| *b | Wire Harness Clamp |
| *c | Guide |
|
Push |
Attach the wire harness clamp and guide to install the No. 2 instrument panel wire.
Connect the 2 airbag connectors and push the lock button to lock.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Be sure to connect the connectors to each corresponding color.
Make sure the lock button is securely locked.
for Single Type:
| *a | Lock Button |
| *b | Wire Harness Clamp |
| *c | Guide |
|
Push |
Attach the wire harness clamp and guide to install the instrument panel wire assembly.
Connect the airbag connector and push the lock button to lock.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Make sure the lock button is securely locked.
55972C
3.INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT
55086
4.INSTALL NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY
55950G
5.INSTALL DEFROSTER NOZZLE ASSEMBLY
6.INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for A25A-FKS:
for M20A-FKS:
for A25A-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
65351A
8.INSTALL BATTERY HOLE COVER (for HV Model)
58416K
9.INSTALL REAR NO. 2 FLOOR BOARD (for HV Model)
58410B
10.INSTALL DECK BOARD ASSEMBLY (for HV Model)
11. PERFORM DIAGNOSTIC SYSTEM CHECK
w/o Occupant Classification System:
for Gasoline Model with Occupant Classification System:
for HV Model with Occupant Classification System:
12.CHECK SRS WARNING LIGHT
w/o Occupant Classification System:
for Gasoline Model with Occupant Classification System:
for HV Model with Occupant Classification System:
13.PERFORM SYSTEM INITIALIZATION AND CALIBRATION