Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL
RM27L0U _54 Brake _049322 BRAKE SYSTEM (OTHER) _0235745 BRAKE PEDAL A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL  INSTALLATION  


PROCEDURE

Hide 47121 1.INSTALL BRAKE PEDAL PAD

a.

Install the brake pedal pad onto the brake pedal.


Hide 55106 2.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY

a.
C154462

Install the brake pedal support with the 4 nuts.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)


b.

Install the No. 3 brake pedal bracket to the brake pedal support.


c.
C208543

Temporarily install the brake pedal support, No. 3 brake pedal bracket and brake pedal lever with the bolt and nut.


d.
C208544E03
2.052,1.604 2.406,1.604 true 2.438,1.521 3.365,2.167 0.927,0.646 10 true Brake Pedal Bracket

Install the bolt to the No. 3 brake pedal bracket.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


e.

Apply lithium soap base glycol grease to the inner surface of the hole on the brake pedal and return spring mounting bracket of the No. 3 brake pedal bracket.


f.

Install the brake pedal return spring.


g.

Tighten the bolt and nut.

Torque:
23 N*m (239 kgf*cm, 17 ft.*lbf)


Hide 47264A 3.INSTALL PUSH ROD PIN

a.

Apply a light coat of lithium soap base glycol grease to the inner surface of the hole on the brake pedal lever.


b.

Set the push rod clevis in place, insert the push rod pin from outside the vehicle and then install a new clip.

NOTICE:

After assembly, check that the pedal operates smoothly.



Hide 84340 4.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

a.

Install the stop light switch mounting adjuster.


Hide 84340 5.INSTALL STOP LIGHT SWITCH ASSEMBLY

Hide 55971C 6.INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT

a.
C154523

Install the defroster nozzle duct with the bolt.


Hide 55046A 8.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 53601 9.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 67914B 12.INSTALL FRONT DOOR SCUFF PLATE LH

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 47101 14.CHECK AND ADJUST BRAKE PEDAL

a.

Check and adjust brake pedal (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL>ADJUSTMENT).


Hide 47201 15.CHECK MASTER CYLINDER PRESSURE SENSOR SIGNAL

a.