Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here



RESULT LIST OF CHECK CAN BUS LINE 
Symptom
Suspected Area
See page
All ECUs and sensors connected to the CAN communication system are not displayed on the Techstream
CAN Bus Line
Click here
The result of "Communication Bus Check" is "Open in CAN Main Bus Line".
Open in CAN Main Bus Line
Click here
The result of "Communication Bus Check" is "Short in CAN Bus Lines".
Short in CAN Bus Lines
Click here
The result of "Communication Bus Check" is "Short to B+ in CAN Bus Line".
Short to B+ in CAN Bus Line
Click here
The result of "Communication Bus Check" is "Short to GND in CAN Bus Line".
Short to GND in CAN Bus Line
Click here

COMMUNICATION STOP MODE TABLE 
Symptom
Suspected Area
See page
Engine not displayed on the Techstream.
ECM Communication Stop Mode
Click here
Gateway not displayed on the Techstream.
Gateway ECU Communication Stop Mode
Click here
ABS/ VSC/ TRC not displayed on the Techstream. *1
Skid control ECU Communication Stop Mode
Click here
Yaw rate/ deceleration sensor not displayed on the Techstream. *1
Yaw Rate Sensor Communication Stop Mode
Click here
Steering angle sensor not displayed on the Techstream. *1
Steering Angle Sensor Communication Stop Mode
Click here
Distance control not displayed on the Techstream. *2
Distance Control ECU Communication Stop Mode
Click here

HINT:
  1. *1: with VSC
  2. *2: with Dynamic radar cruise control