Front A/C:
Symptom
| Suspected Area
| See page
|
Whole functions of the A/C system do not operate.
| 1. HTR fuse
| -
|
2. A/C amplifier
|
Click here
|
3. Integration control and panel assembly
|
Click here
|
4. Wire harness or connector
| -
|
Air Flow Control: No blower operation
| 1. Blower resistor
|
Click here
|
2. Heater relay
|
Click here
|
3. Blower motor
|
Click here
|
4. Heater blower switch
|
Click here
|
5. A/C amplifier
|
Click here
|
6. Integration control and panel assembly
|
Click here
|
7. Wire harness or connector
| -
|
Air Flow Control: No blower control
| 1. Blower motor
|
Click here
|
2. Blower resistor
|
Click here
|
3. Heater blower switch
|
Click here
|
4. A/C amplifier
|
Click here
|
5. Integration control and panel assembly
|
Click here
|
6. Wire harness or connector
| -
|
Air Flow Control: Insufficient air comes out
| 1. Blower motor
|
Click here
|
2. Blower resistor
|
Click here
|
3. Heater blower switch
|
Click here
|
4. A/C amplifier
|
Click here
|
5. Integration control and panel assembly
|
Click here
|
6. Wire harness or connector
| -
|
Temperature Control: No cool air comes out
| 1. Volume of refrigerant
|
Click here
|
2. Drive belt tension
| -
|
3. Refrigerant pressure
|
Click here
|
4. Compressor and magnetic clutch
|
Click here
|
5. A/C pressure sensor
|
Click here
|
6. Condenser fan
| -
|
7. A/C amplifier
|
Click here
|
8. Integration control and panel assembly
|
Click here
|
9. Wire harness or connector
| -
|
Temperature Control: No warm air comes out
| 1. Engine coolant volume
| -
|
2. Evaporator temperature sensor
|
Click here
|
3. Heater radiator unit sub-assembly
|
Click here
|
4. A/C amplifier
|
Click here
|
5. Integration control and panel assembly
|
Click here
|
6. Wire harness or connector
| -
|
Temperature Control: Air comes out warmer or cooler than the set temperature, or response is slow.
| 1. Integration control and panel assembly
|
Click here
|
2. Air mix control servo motor
|
Click here
|
3. Air mix level
| -
|
Temperature Control: No temperature control
| 1. Integration control and panel assembly
|
Click here
|
2. Air mix control servo motor
|
Click here
|
3. Air mix level
| -
|
No air inlet control
| 1. Air inlet control servo motor
|
Click here
|
2. A/C amplifier
|
Click here
|
3. Integration control and panel assembly
|
Click here
|
4. Wire harness or connector
| -
|
No air outlet control
| 1. Integration control and panel assembly
|
Click here
|
2. Air outlet control servo motor
|
Click here
|
3. Air outlet lever
| -
|
Engine idle up does not occur, or is continuous
| 1. Compressor and magnetic clutch
|
Click here
|
2. A/C amplifier
|
Click here
|
3. Integration control and panel assembly
|
Click here
|
4. Wire harness or connector
| -
|
Brightness does not change when rheostat volume or light control switch is operated.
| 1. Illumination light system
| -
|
2. A/C amplifier
|
Click here
|
3. Integration control and panel assembly
|
Click here
|
4. Wire harness or connector
| -
|
Rear A/C:
Symptom
| Suspected Area
| See page
|
Air Flow Control: No blower operation
| 1. Rear blower resistor
|
Click here
|
2. RR A/C relay
|
Click here
|
3. Rear blower motor
|
Click here
|
4. Rear A/C control panel assembly
|
Click here
|
5. Wire harness or connector
| -
|
Air Flow Control: No blower control
| 1. Rear blower motor
|
Click here
|
2. Rear blower resistor
|
Click here
|
3. Rear A/C control panel assembly
|
Click here
|
4. Wire harness or connector
| -
|
Air Flow Control: Insufficient air comes out
| 1. Rear blower motor
|
Click here
|
2. Rear blower resistor
|
Click here
|
3. Rear A/C control panel assembly
|
Click here
|
4. A/C amplifier
|
Click here
|
5. Integration control and panel assembly
|
Click here
|
6. Wire harness or connector
| -
|
Temperature Control: No cool air comes out
| 1. Volume of refrigerant
|
Click here
|
2. Drive belt tension
| -
|
3. Refrigerant pressure
|
Click here
|
4. Rear heater radiator unit sub-assembly
|
Click here
|
5. Compressor and magnetic clutch
|
Click here
|
6. A/C pressure sensor
|
Click here
|
7. Condenser fan
| -
|
8. A/C amplifier
|
Click here
|
9. Rear A/C control panel assembly
|
Click here
|
10. Integration control and panel assembly
|
Click here
|
11. Wire harness or connector
| -
|
Temperature Control: No warm air comes out
| 1. Engine coolant volume
| -
|
2. Rear heater radiator unit sub-assembly
|
Click here
|
3. Rear A/C control panel assembly
|
Click here
|
4. A/C amplifier
|
Click here
|
5. Integration control and panel assembly
|
Click here
|
6. Wire harness or connector
| -
|
Temperature Control: Air comes out warmer or cooler than the set temperature, or response is slow.
| 1. Rear A/C control panel assembly
|
Click here
|
2. Rear air mix control servo motor
|
Click here
|
3. A/C amplifier
|
Click here
|
4. Integration control and panel assembly
|
Click here
|
5. Wire harness or connector
| -
|
6. Air mix level
| -
|
Temperature Control: No temperature control
| 1. Rear A/C control panel assembly
|
Click here
|
2. Rear air mix control servo motor
|
Click here
|
3. A/C amplifier
|
Click here
|
4. Integration control and panel assembly
|
Click here
|
5. Wire harness or connector
| -
|
6. Air mix level
| -
|
No air outlet control
| 1. Rear A/C control panel assembly
|
Click here
|
2. Rear air outlet control servo motor
|
Click here
|
3. A/C amplifier
|
Click here
|
4. Integration control and panel assembly
|
Click here
|
5. Wire harness or connector
| -
|
Brightness does not change when rheostat volume or light control switch is operated.
| 1. Illumination light system
| -
|
2. Rear A/C control panel assembly
|
Click here
|
3. Wire harness or connector
| -
|