Hot fluids.
Risk of scalding.
Conduct all work in the vehicle wearing appropriate personal protective equipment only.
Refrigerant circuit under high pressure.
Danger of injury.
Note and follow safety information on containers.
Avoid contact with refrigerant; wear safety goggles and protective gloves.
For more information see:
Handling refrigerant:
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT>PRECAUTION
Notes on repair work on air conditioning:
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>PRECAUTION
Check that the START-STOP button (engine switch) off.
Pressing and holding the AUDIO button changes the power source mode to IG OFF.
1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
2.DRAIN ENGINE COOLANT (for Low Temperature)
for B48:
Click hereGeneral>MAINTENANCE>B48 COOLANT (for Low Temperature)>REPLACEMENT
for B58:
Click hereGeneral>MAINTENANCE>B58 COOLANT (for Low Temperature)>REPLACEMENT
3.DRAIN ENGINE COOLANT (for High Temperature)
for B48:
Click hereGeneral>MAINTENANCE>B48 COOLANT (for High Temperature)>REPLACEMENT
for B58:
Click hereGeneral>MAINTENANCE>B58 COOLANT (for High Temperature)>REPLACEMENT
16470
4.REMOVE RADIATOR RESERVE TANK ASSEMBLY
5.REMOVE FRONT BUMPER ASSEMBLY
53111M
6.REMOVE FRONT BUMPER INNER SUPPORT
52521B
7.REMOVE FRONT BUMPER UPPER RETAINER
53295A
8.REMOVE RADIATOR UPPER AIR DEFLECTOR
16572D
9.SEPARATE NO. 2 RADIATOR HOSE
Separate the No. 2 radiator hose (1) from the high temperature radiator assembly.
884A0
10.REMOVE COOLER CONDENSER ASSEMBLY
Danger of injury.
Wear safety goggles and protective gloves when disconnecting the refrigerant line. Seal refrigerant lines with seal plugs.
Disengage the lock springs (1) and disconnect No. 5 water by-pass hose (2) and No. 6 water by-pass hose (2) from the cooler condenser assembly.
Catch and dispose of escaping coolant.
Remove T30 bolts (1) and T45 bolts (1).
Disconnect air conditioner tube assembly (2) and discharge tube G (2) from the cooler condenser assembly.
Remove the O-rings.
Remove bolt (3).
Remove the cooler condenser assembly (1) together with the holder.